DXRACER Original Gaming Chair

Quick Installation Guide

Model: NO.2101-0106

This guide provides instructions for assembling your DXRacer Original Gaming Chair.

Important Safety Warnings

• Please use protective gloves when assembling chairs to prevent injuries.
• When adjusting chair height upward or downward, gently push up on the lever. Do not use excessive force to push down on the lever.
• Be mindful of finger pinch points between the mechanism and your hand when adjusting the chair's angle lever.
• Do not over-extend or use excessive force when adjusting the backrest angle.
• When rocking the chair, do not touch the reclining mechanisms to avoid falling.
• Ensure the rocking lever is in the "Lock" position when fully reclining the chair.
• When fully reclining the chair, both feet should remain on the ground. Avoid sudden or excessive force on the backrest, or horseplay, as this could result in the chair tipping over.
• This product is a chair designed for sitting and reclining only. Do not use it as a stepstool, wheelchair, or for any other purpose.
• The chair is designed for use by one person at a time. Do not stand or kneel on the chair.
• Do not sit on the edge of the seat or on the armrests.
• Avoid leaving the chair in direct sunlight to prevent fading and plastic degradation.
• Clean the chair with gentle cleansers when necessary. Do not scrub excessively or use harsh corrosive cleaning agents.
• Check all parts monthly to ensure they are properly assembled and secure for your safety.
• If any part is loose, missing, or damaged, please contact DXRACER immediately and discontinue use.

Product Parts List

Please check that you have all the following parts before assembly:

• Chair Body (A) x1
• Five-Star Base (B) x1
• Gas Lift Cover (C) x1
• Gas Lift Cylinder (D) x1
• Armrests (E) x2
• Seat Plate Mechanism (F) x1
• Lumbar Support Pillow (G) x1
• Headrest Pillow (H) x1
• Casters (I) x5
• M8x20mm Bolts (J) x1
• M5x8mm Bolts (K) x1
• M5x8mm Bolts (L) x2
• M8x20mm Bolts (M) x1
• M8x20mm Bolts (N) x1
• M5x8mm Bolts (P) x1

Installation Steps

Step 1: Base Assembly

Insert the five casters (I) into the sockets on the five-star base (B). Place the gas lift cylinder (D) into the center hole of the base. Slide the gas lift cover (C) over the gas lift cylinder.

Step 2: Attach Seat Mechanism

Align the seat plate mechanism (F) with the mounting points on the underside of the chair body (A). Secure it using the provided bolts (e.g., M5x8mm, M8x20mm).

Step 3: Attach Armrests

Attach the armrests (E) to the sides of the chair body (A) using the appropriate bolts (e.g., M8x20mm).

Step 4: Attach Pillows

Attach the headrest pillow (H) and the lumbar support pillow (G) to the chair body (A) using the integrated straps.

Step 5: Final Assembly

Carefully lift the assembled chair body (A) and place it onto the gas lift cylinder (D) attached to the base.

Contact and Support

For service or inquiries:

• Service Hotline: 400-990-5033
• Official Tmall Website: dxracer.tmall.com
• Company: DXRACER Technology Wuxi Co., Ltd.
• Headquarters Address: 9177 E. M36 Whitmore Lake, MI 48189, USA
• Headquarters Phone: (810) 626-7061
• Email: Contact@dxracer.com
• General Website: www.dxracer.com
• Follow us on: Official Weibo, WeChat Service Account