The Beauty of Nature Awaits

⚠️ WARNING

Paddle sports can be very dangerous and physically demanding. The user of this product should understand that participating in paddle sports may involve serious injury or death. You should receive qualified instructions to learn proper paddling techniques, water safety, and first aid before going boating. Observe the following safety standards whenever using this product.

• ALWAYS wear a nationally approved Life Jacket or Personal Flotation Device (PFD).
• ALWAYS inform someone of your boating route, the time and place of your departure and your intended time and place of arrival.
• This is not a life saving device. Use only under competent supervision.
• Get paddle sports instruction from a licensed or certified instructor. Be sure to carry first aid and rescue equipment with you.
• Read the complete Owner's Manual before use and store this Manual in a safe place for future reference.
• Check your equipment prior to each use for signs of wear leaks or failure.
• Dress appropriately for weather conditions. Boating in cold water and cold weather is very dangerous. Hypothermia may lead to death.
• Know and follow local water safety rules and boating regulations.
• DO NOT consume alcohol or use drugs that affect your ability to safely operate the boat before using this product.
• DO NOT exceed your paddling ability; be honest with yourself.
• DO NOT impair entry or exit access to the kayak when installing additional outfitting.
• DO NOT overinflate or use high pressure air compressor to inflate.
• NEVER go paddle in bad weather or dangerous waters such as severe winds, rainstorm, flood waters, tidal changes, etc.
• NEVER paddle alone. Minors need to use this boat under adult supervision.
• NEVER allow diving into this product. Never leave in or near the water when not in use. Never tow from any vehicle.
• When carrying the kayak, try to lift it off the ground as much as possible and do not drag it.
• Be careful of rocks or shells, as well as any objects that can scratch their surface.

DESCRIPTION

Diagram of the inflatable kayak with numbered parts:

• 1. Transport Handle
• 2. Warning label
• 3. Zipper
• 4. Seat Adjustment Velcro
• 5. Seat D-ring
• 6. Safety Handle
• 7. Paddle Holder
• 8. Floor Chamber Valve
• 9. Side Chamber Valve
• 10. Secure Bungee Tie-Down
• 11. Drain Valve
• 12. Detachable Skeg
• 13. Directional Strake

[Top-down and side view illustrations of the kayak with numbered features]

STANDARD EQUIPMENT

The following equipment is included with the kayak:

• 1. Adjustable Seats (2) [Illustration of a padded seat]
• 2. Adjustable Foot Rests (2) [Illustration of foot rests]
• 3. Inflatable Child Seat (or dog) [Illustration of a child seat]
• 4. Double-sided Aluminum Alloy Paddles (2) [Illustration of two paddles]
• 5. Repair Kit [Illustration of a repair kit with patches, glue, tool]
• 6. Strap [Illustration of a strap]
• 7. Interconnecting Nozzles [Illustration of pump nozzles]
• 8. Carry Bag [Illustration of a carry bag]
• 9. Removable Skeg [Illustration of a skeg]
• 10. Double Action Hand Pump [Illustration of a hand pump]

PRODUCT INFORMATION

Important Notes:

• Kindly note that the pressure gauge will not change until the kayak is inflated to 5 PSI.
• Please do not overinflate the Side Chamber Valve to avoid damage.
• The Floor Chamber Valve needs to be continuously inflated to make the pressure gauge display the correct pressure value.

ASSEMBLY TIPS

1. Locate a clean area free of stones or other sharp objects, unfold and spread out kayak flat, fill each chamber until it is stiff to the touch but NOT hard.
2. This hand pump includes 3 interconnecting nozzles with hoses to inflate the kayak. Remove adapter hose from inflation port and attach to inflatable port. [Illustration of pump components and hose connection - Figure A]
3. Unscrew the cap of this double action pump for saving your energy when you pump. [Illustration of the double action pump with cap highlighted - Figure B]

HOW TO USE

Removable Skeg

It is recommended to use the detachable skeg in deep water (lake, sea) where it will allow you to move forward in a straight line. Do not use it in shallow water or white water: the skeg would deteriorate the bottom of the kayak in shallow water and reduce the maneuverability in white water. After the skeg is assembled, please push the lock pin in the skeg. The skeg cannot be installed when the kayak is fully inflated. The curvature of the skeg must be pointed towards the back end of the kayak. [Illustration showing skeg attachment and lock pin - Figure C]

Side Chamber Valve

1. Unscrew the valve cap counterclockwise from Valve Insert. [Illustration of valve cap and insert - Figure D]
2. Insert the pump hose end piece and inflate it until you will reach the required pressure. [Illustration of pump hose in valve - Figure E]
3. After inflation, tighten the valve caps clockwise to prevent air from leaking.
4. To release air from the side tubes, unscrew the valve insert from the valve base counterclockwise.

Floor Chamber Valve

1. Unscrew the valve cap counterclockwise from valve insert. [Illustration of valve parts - Figure F]
2. Insert the pump hose end piece and inflate it until you will reach the required pressure. [Illustration of pump hose in valve - Figure G]
3. After inflation, tighten the valve caps clockwise to prevent air from leaking.
4. To release air from the bottom tube, press the valve insert from the valve base counterclockwise. [Illustration of valve base and insert - Figure H]

Adjustable Seats

Equipped with 1 padded child seat. Place the seat into the kayak to match the position of the velcro strips on the floor (in the middle). [Illustration of seat placement on floor velcro - Figure I]

Equipped with 2 adjustable foot rests that allow riders to have a sturdy base to brace against when paddling. Place the foot rests into the kayak to match the position of the velcro strips on the floor (before the adjustable seats). [Illustration of foot rest placement on floor velcro - Figure J]

Equipped with 2 adjustable seats. Place the seat into the kayak to match the position of the velcro strips on the floor. And fasten the straps from the sides of the backrest to the D-rings on the inside of the kayak. Tighten the straps as needed for proper back support. You can choose the seat position for one or two persons. [Illustration of seat straps attached to D-rings - Figure H]

CUSTOMER SUPPORT

Go to Your Orders, find your order in list, and click get product support.

You can e-mail the seller by doing the following:

Account & Lists | Orders | Try

Your Account

• Your Account
• Your Orders [Orders: Open Orders, Digital Orders]
• Your Orders [1 order placed in past 6 months]
• Your Dash Buttons
• Your Lists

Get product support

Write a product review

Archive order

Talk to an expert

Figure out and fix what's wrong. get

phone | chat

If a new window doesn't appear, change your browser settings.

Steps to get support:

1. Go to your account and find the order.
2. Find your order item.
3. Click get product support.
4. Give the seller 24 hours to respond.

Problem with the order? Please email us: WolfArmorUSA@hotmail.com. Give us a chance to help you first.

Do you love your new WOLF ARMOR product? Help others find it by leaving a product review online!