USER MENU

Power ON/OFF

Power ON: Press and hold the power button till to GREEN LED blinks or light up.
Power OFF: Press and hold the power button till to the RED LED flashing.

Pairing(Register mode)

a). Press and hold the power button to turn headset power ON, the power LED should blink in Green color.
b). Enter the pairing mode: Press the volumeUnder down button at 3 times continually, then press and hold theUp volume up till to the RED and Green LED blinking at alternately.
c). Main unit enter the pairing mode first then also the Remote to pairing mode.
d). The Green LED of Remote headset will several blinks fastly then turn off after paired, press the power button to quit the pairing mode, keep the Main unit on the pairing mode then can pair with more Remote or press the power button to quit the pairing mode.
e). Repeat the above step “d” for more Remote headsets paired with the same Master, or press the power button to finish the pairing(register). (Note: . The Mani headset can accept maximum 8 remotes register in full-duplex, or all the remotes fixed on listening mode, total register number over 250 headsets available on listening mode.

Talking and listening

a). The Main and Remote headset will start to search each other after power ON, the GREEN LED flash 1 time every 3 seconds. The headset will be linked together automatically when the pairing ID is confirmed by the master and the LED turns ON in GREEN color.
b). Press the volume upUp and Underdown button to adjust the headset speaker sound volume.

Mic Muted

The headset Microphone stopped automatically when the Mic boom swivel up.

FCC Warning:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement:
This equipment has been tested SAR and complies with FCC radiation exposure limits set forth for an uncontrolled environment.
IC Warning:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

IC Radiation Exposure Statement:
This equipment has been tested SAR and complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
To prevent possible hearing damage, do not listen at high volume levels for long periods

Documents / Resources

PORTA PHONE EVXR 2.4 GHz Transceiver-Remote [pdf] User Manual
EVXR, B4HEVXR, EVXR 2.4 GHz Transceiver-Remote, EVXR, 2.4 GHz Transceiver-Remote

Leave a comment

Your email address will not be published.