ASRock Radeon RX 7900 XTX AQUA 24GB OC
Liquid Cooling Quick Installation Guide
Liquid Cooling Your Graphics Card
The ASRock Radeon RX 7900 XTX AQUA 24GB OC graphics card is equipped with a unique AQUA liquid cooling system, offering great cooling efficiency and high performance. The instructions below demonstrate how to install the water pipes on the graphics card.
Before Installation
- Read this installation guide carefully before installing the RX 7900 XTX AQUA graphics card.
- Please use appropriate liquid cooling materials to ensure efficient heat dissipation.
- Make sure that the air in the pipes is completely exhausted.
Installation Procedures
- Choose either Method A (Front side) or Method B (Rear side) to liquid cool your graphic card.
- Locate the correct inlet and outlet ports.
- Tighten two G1/4" water plugs.
- Install liquid cooling pipes.
ATTENTION! Please make sure you connect the inlet (cool water) and outlet (warm water) pipes correctly as shown below.
A. Front Side
Diagram showing the front of the graphics card. It illustrates two connection ports:
- Inlet pipe (cool water): This port receives cool water.
- Outlet pipe (warm water): This port releases warm water.
Two G1/4" water plugs are shown, indicating where to secure the fittings.
Visual representation of water flow: Blue arrows indicate cool water entering the inlet, and orange arrows indicate warm water exiting the outlet.
B. Rear Side
Diagram showing the rear of the graphics card. It illustrates two connection ports:
- Inlet pipe (cool water): This port receives cool water.
- Outlet pipe (warm water): This port releases warm water.
Two G1/4" water plugs are shown, indicating where to secure the fittings.
Visual representation of water flow: Blue arrows indicate cool water entering the inlet, and orange arrows indicate warm water exiting the outlet.
