PHILIPS-Logo

PHILIPS 9454090431 Hue 4″ Color Downlight Retrofit

PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Product-Image

Incl.

PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-01

Features

PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-02

IMPORTANT SAFETY INSTRUCTIONS

THIS PORTABLE LUMINAIRE HAS A POLARIZED PLUG (ONE BLADE WIDER THAN THE OTHER) AS A FEATURE TO REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY INSERTED. DO NOT ALTER THE PLUG.

  • Product appearance may vary from image shown.

Installation

PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-03PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-04PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-05PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-06

Single bulb

  • Wirelessly controllable LED bulb
  • Dimmable only With Hue compatible devices
  • Richer colors

PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-07PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-08PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-09

Please & to www.meethue.com to learn more about Hue and how to use It For Information on energy consumption please eo to www.meethue.com/energyconsumptlon. This device complies with Part 15 of the FCC Rules and with RSS of Industry Canada. Operation ts subject to the following two conditions: (1) this device may not cause harmfa Interference, and (2) ttns device must accept arry Interference received, Including interference that may cause undesired operation.
This Cass B digital apparatus complies with Canadian ICES-005. This digital apparatus does not exceed the class B limits for radio-noise emissions from dlel as set out In the Radio Interference Regulations of the Canadian Department of Coovnunicatlons

NOTICE: Changes Of modifications made to this device not expressly approved by Signify North America Colporatlon (“Sianjfy’) may void the U5. FCC and
Canadian author1zatlon to operate this device.
The advanced interface module compiles with FCC radiation eJCP(l!lll! Hmtts set forth for an uncontrolled environment
This device should be Installed and operated with a minimum distance of 7.9 tnches/20 centimeters between the radiatOf and yoa body,
The manufacturer ls not responsible for arry radio or lV Interference caused by unauthor1zed modifications to this equipment. Such mocllncatlons could void the user’s authority to operate the equipment
This device has been tested and found to amply with the limits for a Oass B digital device pursuant to Part 15 of the FCC rules. These bmits are designed to provide reasonable protection apinst harmful Interference In a residential lnstallatlon.Thls device eenerates1 uses, and can radiate radio frequency energy and, If not lnstailed and used In accordance wrth the instl’Uctlons, may cause harmful Interference to l’ilCJ10 communcations.
However, there ls no piarantee that Interference will not oca. In a particular installation. If this device does cause harmful interference to radio or television reception, which r.an be determined by timeline the device off and on, the user ls encouraged to tJy to cooed the Interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna
  • lncrease the separation between the device and receiver
  • Connect the device into an outlet on a circuit different from that to which the receiver is connected
  • Consult the dealer or an experienced radio/television technician for help

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
caution: To maintain compliance with the FCC’s RF exposure IIJldelines, place the product at least 7.9″/20 a from nearby persons

WARNINGS AND CAUTI0NS: Not for use tn totally enclosed or recessed fixtures. Not suitable for use with dllTvners unless specifically designed for Philips
Hue.
Risk of electric shock – Do not use where directly exposed to water This device ls not intended for use with emergency exit fixtures or emergency tights. Only Install in operating environments between -4″F and 104°F (-20″C and 40’C).
LIMITED WARRANTY: This product ls covered by a 3 year Umlted Warranty. The complete Umtted Warranty, warnings and cautions are Included tnSide
this packaging, and are also available at www.meethue.com/warranty

Cleaning AND MAINTENANCE: Do not dean the device when It ls on and connected to the power supply. To avoid scratching the device, dean only
with a soft dry doth. Do not use deaning agents to dean the device Manaee In accordance wrth disposal laws In the YWf area. WlrwlBs Spedfution: Wlreless Rf mode frequency band: 2400-2483.5 MHz
Operating channels Ziebee: channels 11 – 26
Operation channels Bluetooth: channels 0-39
Bluetooth• enabled product.

Environmental specifications:
Temperature (operation): -20_45″C
Temperature (Storage): 25-60 -C
Relative humidity: 5-95 % non-condensing
Standby power: <05W per lamp

The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG,Inc. and any use of such marks by Signify is under license. Other trademarks and trade names are those of their respective owners.

PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-10

SAFETY INSTRUCTIONS- PART B

  • The manufacturer advises the correct use of Luminaires (lighting fixtures)! Therefore always follow these instructions to ensure correct and safe installation and functioning of the luminaire and keep it for future reference.
  • Turn off electrical power at main fuse or circuit breaker box before commencing installation, maintenance or repair.
  • If in doubt, consult a qualified electrician or contact your retail outlet. Ensure that you always install the luminiare to the local electrical code. Certain regulations indicate that luminaires should be installed by a qualified electrician.
  • Observe the correct color of the wiring before installation: white (N), black (L) and green or bare copper wire (Ground).
  • Do not connect this luminaire to a non-grounded electrical system.WARNING: Installing this fixture in a non-grounded electrical system could allow metal parts of the luminaire to carry electrical current if any wires or wire connections become broken or loose. Under this condition, anyone coming in contact with the luminaire is subject to electric shock which could cause injury or death.
    *Always use wire nuts/connectors rated for the correct gauge and number of wires used. CAUTION: Be certain that no bare wire strands are exposed outside of the wire nuts/connections (if applicable).
  • Be careful not to damage or cut the wire insulation (covering) during installation. Do not permit wires to contact any sharp edges.
  • Do not remove thermal insulation pad(s). Doing so will result in increased temperatures and possible risk of fire.
  • Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents.Avoid liquid on all electrical parts.
  • Always consider all the technical specifications of the luminaire.Verify the stated icons on the identification label on the luminaire and the icons that are shown in part A of your safety instructions.

ATTENTION: Below you will find all the explanations with numeric references to the icons respectively in front of these PART-B safety instructions. Applicable icons to your fixture are shown in PART-A safety instructions.

  1. This luminaire should only be installed indoors.
  2. The luminaire is suitable for outdoor usage.
  3. Only suitable for dry locations.
  4. Suitable for damp locations.
  5. Suitable for wet locations.
  6. Luminaire is suitable for base up mounting
  7. Luminaire is suitable for base down mounting.
  8. Luminaire is suitable for horizontal mounting
  9. The luminaire is only suitable for fixing to the ceiling.
  10. The luminaire is only suitable for fixing to the wall.
  11. The luminaire is suitable for fixing to the wall and to the ceiling
  12. Always observe the minimum distance between the lamp and the surface being lit as indicated on the icon.
  13. Free air space of at least 4 inches must be kept between top of shade and bottom of canopy.
  14. Immediately replace a cracked or broken safety glass and use only manufacturer approved parts.
  15. Strip the wire as indicated in the diagram.
  16. Use heat-resistant cable for wiring the luminaire into the mains
  17. MAX….W: only use lamps suitable for this luminaire and keep within the maximum specified wattage.
  18. This product is not suitable for children under 14 years
  19. The Luminaire has a ground conductor identified with green insulation or bare copper wire.
  20. The luminaire is only suitable for a lamp with built-in safety or a low pressure lamp.An extra safety glass is not necessary.
  21. Capsule and linear halogen lamps may not be touched by bare hands.
  22. The luminaire is equipped with a fuse. If the luminaire is out of order after the bulb has been replaced, the internal fuse has to be replaced. If contact with the internal wiring can be made during this operation, this should be done by a competent electrician.
  23. The luminaire can be used with a dimming circuit. Consult a qualified electrician for choosing the right type (especially important for low voltage luminaires).
  24. The Luminaire cannot be used with a dimming circuit
  25. The luminaire is dimmable with the supplied dimmer ONLY. Do not connect to an additional dimmer
  26. The dimmability features depend on the chosen lamp. More information on the dimmability features is available in the information pack provided with the bulb.
  27. Luminaire with time and light setting options. Minimum and maximum will be shown in the icon in partA.
  28. The luminaire can be placed at a maximum of 20ft height
  29. To reach an optimal working, you have to place the luminaire on the height mentioned in the icon.The maximum and minimum reach of the detector is also mentioned in the icon in part A.
  30. The standard active range of vision of the detector covers the given degrees mentioned in the icon.
  31. Ensure that you don’t drill through electrical wires or any other obstruction in the wall or ceiling during installation!
  32. This luminaire contains in some places very hot parts.
  33. Product to be installed by two people.
  34. The product is for indoor use only. Do not use in wet locations, areas directly exposed to water or outdoors.
  35. The product is ZigBee certified. Zigbee is an open standard for indoor wireless communication. All Philips ZigBee Certified products can be connected with other Philips ZigBee Certified products.
  36. Bluetoodh enabled product. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Signity is under license. Other trademarks and trade names are those of their respective owners

Sgnity warrants that this device wil be free from detects in material and workmanship and will operate for 2 years, unless a diferent period is stated in or on the packaging of the product, based on up to 3 hours average working time per day/7 days per week when used as directed. If this device does not conform to the warranty, Signify will send you, at its election, a replacement device or refund your original price upon receipt of the returned device, register receipt and proof of purchase. Please call our toll-free number, 1-800-55S-0050, or write to us (address indicated on the paclkaging) to find out how to return the device. This limited warranty does not cover devices subject to accident, neglect, abuse, misuse or acts of God. REPLACEMENT OR REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSELY EXCLUDED. Some states and provinces do not allow exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state and province to province. Philips and the Philips Shield Emblem are registered trademarks of Koninkljke Philips N.M.
Alterations in design and technical specifications reserved.
“Hue Personal Wireless Lighting” is a trademark owned by Signify Holding B.V.

Signify North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA

Questions or Comments
1-800-555-0050
www.meethue.com

PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-12PHILIPS-9454090431-Hue-4″-Color-Downlight-Retrofit-Fig-11

Documents / Resources

PHILIPS 9454090431 Hue 4" Color Downlight Retrofit [pdf] User Guide
9454090431 Hue 4 Color Downlight Retrofit, 9454090431, Hue 4 Color Downlight Retrofit, Downlight Retrofit, Retrofit

References

Leave a comment

Your email address will not be published. Required fields are marked *