Pama logoWireless Charging Auto-Grip Phone Holder

Contains
 Wireless charging pad, windscreen mount, air vent clip & Type C USB cable

Pama Wireless Charging Auto-

This 2-in-1 holder and wireless charger are compatible with wireless charging phones. Move your phone towards the holder to activate the automatic arms. Whilst in the holder, your compatible mobile phone will automatically charge.

Instructions for use

  1. To attach the charging pad to your preferred mount, loosen the wheel on the back, push in the pivot ball of the mount, and re-tighten the screw.
  2. Set up the charger in your preferred place in the car, ensuring it is securely in place. Windscreen or dash mount ­ Adhesive gel pad enables the holder to be mounted on the dashboard as well as on the windscreen. Please ensure the gel pad is kept clean to provide effective adhesion, if the gel pad becomes dry and dirty simply rinse with water and let it dry. Vent Mount ­ Press down on the lever to open the clamp and attach to car vent slots.
  3. Connect the cable to the port at the bottom of the charging pad and to your car charger’s USB port.
  4. The green LED light on the base of the charging pad indicates that the charger is on.
  5. The arms will open automatically when you put your phone against the holder. Touch the silver sensor on the bottom left side of the cradle to remove your phone, or if your arms do not open automatically.

Safety

Protection 

  • Overvoltage protection.
  • Over-current protection.
  • Over-temperature protection.

Precautions

  • If you have a protective case on your Qi Wireless mobile phone, you can still charge with the case on, provided the case does not have metallic studs, a magnetic clasp, does not contain a magnetic/metal plate, and does not create distance between the charging pad and the back of the phone greater than 8mm
  • Medical implants – Please maintain a minimum of 20cm safe distance between the Wireless Charging holder (when powered ON) and any medical implants that can be affected by a magnetic field, such as pacemakers.
  • Do not immerse in liquid.
  • Do not place a magnet or any magnetically sensitive devices such as credit cards on the charging pad.
  • Do not obstruct the driver’s view and maintain full control of the vehicle at all times.
  • Please keep away from children, this is not a toy.

Specification

Input DC 5V/2A OR 9V/1.67A
Output 10W, 7.5W, 5W
Max. Charging Distance 8mm
Efficiency Approx. 75%
Frequency 110-205KHz
Status Indicator LED
Holder Type Vent clamp or gel pad
Placement Windscreen/Dash/Vent

Please note: To reach the maximum output, the charger must be used with a QC Charger.

Warranty

  • The condition of this warranty and our responsibilities under this warranty are as follows: the warranty is non-transferable and is limited to the original purchaser only.
  • You must be able to prove the date of the original purchase of the unit with a dated receipt.
  • The warranty is not applicable if the product has been subject to physical abuse, improper installation, modification, or repair by unauthorized third parties.
  • The liability of the supplier shall be limited to the repair or replacement of the product at its sole discretion.
  • Specifically exempt from any warranty are limited-life consumable components subject to normal wear and tear, such as batteries and other accessories.
  • The supplier will not take any responsibility if the failure of the unit has resulted from accident, abuse, misuse, or any unauthorized repair, modification, or disassembly.
  • Modification and repair of this device must be done by an authorized and qualified service center or returned to the manufacturer.
  • This warranty gives you specific legal rights, and you may also have other rights which vary under local law.

DustbinIf at any time in the future you should need to dispose of this product, please note that electrical goods should not be disposed of with household waste.
Please take it to your nearest recycling center. Check with your local authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
BRANCH V1
©2019 Pama England – E&OE All trademarks owned & operated by their respective companies
Made in China
www.pama.com
Helpline: +44 (0) 161 494 4200

Documents / Resources

Pama Wireless Charging Auto-Grip Phone Holder [pdf] User Manual
Pama, Wireless, Charging, Auto-Grip, Phone Holder, BRKWCAH V1

References

Leave a comment

Your email address will not be published.