OSKULL CBS01 Compact Bluetooth Speaker User Manual

Warning:
Any changes or modifications not approved by the responsible party may void the user’s authority to operate the equipment.
Follow these steps to optimize performance:

Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Connect the device to a different circuit than the receiver’s.
Consult a dealer or experienced technician for assistance.

RF Warning Statement:
The device is evaluated for general RF exposure requirements. It can be used in portable conditions without restrictions.

PRODUCT OVERVIEW

Charging Status Indicator

Red light on
White light on
Red light flashes
Being Charged
Fully Charged
Low Battery

Power On
Press and hold the button for 2 seconds.
Make sure the speaker is fully charged before first use.

Power Off
Press and hold the button for 3 seconds.

Connecting devices

Turn on Bluetooth on your mobile device.
Turn on the speaker, find “OSKULLO3” in the list of pairable devices, and click to connect the speaker.
Once the device is connected, the indicator light on the speaker will turn off automatically.

Music Control

Play / Pause
Click the button once
Volume up
Click the + button once
Volume down
Click the – button once
Previous track
Press the – button for 1 second
Next track
Press the + button for 1 second

Call management

Answer / Hang up
Click the button once

Reject Call
Press the button for 1 second

Voice Assistant
Click the button twice

Pairing Troubleshooting

Pairing Failed

Turn the speaker off and then back on.
The speaker will automatically enter pairing mode and wait for a connection. If the above solution does not work, follow the instructions below to reset the pairing history.
Remove the speaker from your paired list.
When the speaker is turned on and not connected to any device, press the multi-function button three times in succession to clear the pairing record, and then wait for the speaker to connect to the mobile device.

Can’t Pair with Mobile Device
After the speaker is turned on, it will automatically pair with the last connected device. If it is not paired, you need to connect manually.

NOTE: If disconnected or pairing time exceeds 3 minutes, the speaker will automatically power off.

Device status indication

Low Battery Warning

The speaker plays a low battery warning prompt.
Red light flashes.

Low Power Shutdown

The speaker plays a power off prompt.
Red and blue lights flash alternately

Charging status

Red light on
The speaker is charging
White light on
The speaker is fully charged
White light off
Disconnected from charging

Note:

Make sure the speaker is fully charged before first use.
It is recommended to fully charge before use to maintain the health of the battery
If not used for a long time, please charge it at least once every 45 days.

Product Specifications

Model: OSKULLCBS01
FCCID: ID:2BMB4-OSKULLCBS01
Bluetooth Version: V5.4
Waterproof Level: IP67
Rated Voltage / Current: 5V / 1A
Rated Power: 300mW
Frequency Response: 20Hz – 20kHz
Battery : 3.7V / 560 mAh
Supported Profiles :
A2DP1.4 / AVCTV1.4 / AVDTP1.3 / AVRCP1.6.2
HFP 1.8 / SPP 1.2 / RFCOMM1.2 / PNP1.3/ HID1.1.1
SDP CORE5.4 / 12CAP CORE5.4
Audio Codec: AAC / SBC
Driver Unit Impedance / Power: 20 / 2W
Mic Sensitivity : -42dB # 1dB
Transmission Distance: 10 meters
Working Time: 14 hours (@80% Volume)
Standby Time: About 400 days
Charging Time: About 2 hours
Product Weight: 62g

OSKULL.COM

BLUE WHALE BRAND MANAGEMENT CO., LTD.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

FAQ

Q: Can I make modifications to the device?
A: No, any changes or modifications not approved may void your authority to operate the equipment.

Q: Is there a restriction on where I can use the device?
A: The device can be used in portable conditions without restrictions on exposure.

Documents / Resources

OSKULL CBS01 Compact Bluetooth Speaker [pdf] User Manual
2BMB4-OSKULLCBS01, 2BMB4OSKULLCBS01, oskullcbs01, CBS01 Compact Bluetooth Speaker, CBS01, Compact Bluetooth Speaker, Bluetooth Speaker, Speaker

References

User Manual

OSKULL CBS01 Compact Bluetooth Speaker

Product Information

Product Usage Instructions