VinDox Cat Water Fountain User Guide

Pet Fountain: Before we start: Care Instructions

In order to provide your pet with fresh and clean water continuously, please remember these three simple tasks:

• Refill often.

  Keep the water level. The pump is designed to work in water at least one inch deep. If the pump dries, it may malfunction.

• Clean your pump and your fountain.

  Take your pump and fountain apart to clean with soap and water every two to four weeks. Be careful not to get soap in the filters, as it will not rinse out.

• Replace your filters.

  Replace the carbon filter every four weeks when you clean your fountain. Replace the foam filter every two months.

What you have:

The VinDox Cat Water Fountain includes the following components:

• Fountain Basin
• Water Tray
• Pump Holder
• Pump Body
• Pump Cover
• Impeller
• Foam Filter
• Activated Carbon Filter
• Power Adapter

Setup Instructions

1. Install the pump holder first, then put the pump into the sponge. Put the activated carbon filter in the filter hosing and close it.
2. Soak the filter in a clean bowl for 5 minutes.
   Notes:
   1. The filter must be fully soaked before the fountain is turned on; Otherwise, the water may not diffuse through the filter and cause overflow.
   2. Do not soak the filter in the fountain tank to avoid dust on the surface.
3. Open the cover and put back the cover to form a seal.
4. Connect the power adaptor.

Use Instructions

Place the fountain where your pet will use it. Fill the bowl with water, leaving a half inch of space between the water and the rim. Make sure your hands, the cord and the power adaptor are dry, then plug the fountain into an outlet.

Keep health and happiness flowing!

Clean the pump and fountain every two weeks.

Take off the pump cover and rotor. Use the brush to clean the parts with water.