WINCO SDAL-1W instruksjonsbok for automatisk såpedispenser
RECOMMENDED: DUE TO VARIATION IN LIQUID/GEL SOAP THICKNESSES, DISPENSER PUMP MAY NEED TO BE PRIMED TO GET IT STARTED:
- With the container removed from unit, fill container with soap & cap on. Then press the pump BY HAND approximately 5 times until soap comes out.
- Install container in unit, close cover and turn on.
MONTERING AV DISPENSEREN
OPTION 1: with DOUBLE-SIDED ADHESIVE
- Place double-sided self-stick adhesive strips on back of unit and stick onto wall.
For best results, adhere to a smooth surface that is clean and dry.
To clean, wipe surface until dry and use rubbing alcohol to clean the surface.
OPTION 2: with MOUNTING HARDWARE
- Press the button located at the top-rear of the dispenser to open the unit (Fig.1).
- Remove soap container prior to mounting.
- Place the dispenser on desired wall location.
- Mark and install wall anchors.
- Mount unit using screws and washers.
LOCKING THE UNIT (optional)
- Close dispenser cover and insert locking key (included) into the button located at the top-rear (Fig.1).
- Turn key to lock unit, keep key in safe place.
FILLING THE DISPENSER
NOTAT: CHECK THE UNIT FOR CORRECT FILL TYPE
- SKUMNING
- LIQUID / GEL
- Open the unit by pressing the button located at the top-rear of the dispenser (Fig.2).
NOTE: the key will be required if unit was locked with the key (Fig. 1). - Unscrew the cap (Fig.3) and fill the container with soap.
- Reinstall the cap and close the unit.
OPERATING THE DISPENSER
- Load (6) alkaline AA batteries into battery compartment.
- Select a dispense setting, then close cover: 1 = one drop | 2 = two drops | 3 = three drops
For public use, recommend to set to one drop.
INDICATOR LIGHT WILL BLINK WHEN BATTERIES NEED TO BE REPLACED.
Dokumenter / Ressurser
 |
WINCO SDAL-1W automatisk såpedispenser [pdf] Bruksanvisning SDAL-1W, SDAL-1K, SDAF-1W, SDAF-1K, Automatic Soap Dispenser |
