Connecting the Plantronics Savi 8200 Series Headset to a Desk Phone with an EHS Cable

An Electronic Hook Switch (EHS) cable allows the headset to engage the phone without having to remove the handset from the cradle. Electronic Hook Switch Cables (EHS) (sold separately) provide remote desk phone call control (answer/end) with your Plantronics wireless headset system.

Follow the instructions below to connect your headset base unit to a desk phone using an Electronic Hook Switch (EHS) cable.

  1. Connect the end of the EHS cable to the back of the headset base unit.

NOTE: The APP-51 EHS cable shown in the graphic below can be used with all Poly VVX phones, as well as a number of other devices. To check your phone for compatibility, click here.

  1. Connect the other end of the EHS cable to the desk phone as described in the EHS Adapter Getting Started guide that came with the cable.

NOTE: The desk phone and handset will continue to function like normal.

  1. Press the Call Control button on the headset to hear a dial tone.
  2. Dial a test call from the desk phone. If needed, fine-tune the volume with the headset volume controls. You can also adjust the speaking and listening volumes on the desk phone.

NOTE: The minimum recommended separation distance between your desk phone and the headset base unit is 6 inches. Incorrect positioning may cause noise and interference problems that lead to poor audio quality.

Ask a question

Your email address will not be published.