Newair NCH1K5BK00 1500 Count Built-In Cigar Humidor User Guide

Newair NCH1K5BK00 1500 Count Built-In Cigar Humidor

How to operate your cigar humidor

1. Let your cigar humidor sit upright for 24 hours before turning it on. During this time, it is recommended that you leave the door open to clear any residual odors.
2. It is recommended that you setup the cigar cabinet in a place where the ambient temperature is between 50 -77°F. If the ambient temperature is above or below recommended temperatures, the performance of the unit may be affected.
3. It is normal to experience a +/-5% fluctuation in the set humidity level. It is suggested to monitor the humidity level to assess if the cigar humidor levels need to be adjusted.

How to season your cigar humidor

It is best to season your wood shelves and drawers before adding your cigars so that the wood is at an ideal relative humidity (RH) and does not absorb humidity from your cigars. To season your new cigar humidor:

1. Add distilled water to the included moisture container or add a sponge that is damp with distilled water. Make sure that the water is not touching the wood directly or this may damage the wood.
2. Allow the moisture container, or other humidity-adding device, to sit in the humidor until it reaches a relative humidity of 5% higher than your preferred level. This process may take as long as 3 days but is the best way to ensure your cigars stay in the optimal condition.
3. Once the humidor reaches this mark, you can begin to add cigars. You may add a few at a time in order to monitor the RH and make sure it stays at a level you want it at. If it drops too much, you can use the same seasoning method to bring it back up.

How to install the kick plate

1. Remove the kick plate from the cabinet along with the short (4) and long (4) metal screws.
2. Press the kick plate into the opening at bottom of the humidor so that the holes on the side of the kick plate are aligned with the holes on the sides of the brackets. Screw in the short screws to secure the kick plate to the bracket.
3. Tilt the cigar humidor cabinet back 30 degrees. Screw the long screw into the screw holes at the bottom of the kick plate to secure the kick plate in place.

Documents / Resources