Dantherm Group - Commercial Climate Solutions and Systems
Owner's Manual for Dantherm models including: CPD 85, CPD 85 Ducted Swimming Pool and Industrial Dehumidifiers, Ducted Swimming Pool and Industrial Dehumidifiers, Swimming Pool and Industrial Dehumidifiers, Pool and Industrial Dehumidifiers, Industrial Dehumidifiers, Dehumidifiers
3 MAD DENMARK Ducted swimming pool and industrial dehumidifiers CDP 85-135-175 Constant flow fan capabilities The new models are designed to maintain a constant volumetric flow rate, with adjustable minimum and maximum
17 нояб. 2024 г. — The new models are designed to maintain a constant volumetric flow rate, with adjustable minimum and maximum setpoints available via the 2.4-inch touch ...
File Info : application/pdf, 8 Pages, 1.20MB
DocumentDocumentDUCTED SWIMMING POOL & INDUSTRIAL DEHUMIDIFIERS CPD 85-135-175 IDEAL FOR HOTEL POOLS, PRIVATE POOLS, THERAPY POOLS AND MORE Ducted swimming pool and industrial dehumidifiers CDP 85-135-175 High-capacity pool dehumidification Based on its renowned predecessor CDP 75-125-165, this range of ducted pool dehumidifiers offers new controller hardware and control strategies developed to further improve performance, user-friendliness and energy efficiency. Having been through extensive testing at our inhouse testing facility, the range of ducted CDP dehumidifiers comes delivered in a largely unchanged robust cabinet to facilitate easy replacement of older CDP units where required. While the exterior might look familiar and unchanged, the interior has been completely upgraded with new technology. The following lays out some of the most significant changes. MADE IN DENMARK 2 Ducted swimming pool and industrial dehumidifiers CDP 85-135-175 Constant flow fan capabilities The new models are designed to maintain a constant volumetric flow rate, with adjustable minimum and maximum setpoints available via the 2.4-inch touch display. The available volumetric flow ranges are as follows: 500-1500 m³/h for the 85 model, 1200-2500 m³/h for the 135 model, and 1500-3600 m³/h for the 175 model. Figure 1 below shows the operational airflow range, which is consistent across all sizes. Thanks to the centrifugal EC fan, the system can handle increased external pressure drops, making it suitable for longer ductwork and additional air vents or grilles. Figure 1 Operational range depending on minimum and maximum airflow of the given unit size. New refrigerant reducing CO2 equivalent by over 95% To meet the requirements of the EU F-Gas regulation, the new CDP models use refrigerant 454C, which has a GWP of 148 (IPCC, AR4, 2007). The fin-and-tube condenser has been replaced with a micro-channel condenser. This change reduces the internal volume of the cooling circuit and the overall refrigerant charge, while also improving heat transfer efficiency. Optional internal re-heaters The redesigned condenser allows for the inclusion of an internal re-heater, which helps maintain a set room temperature. The internal low-pressure hot water (LPHW) coil can be integrated during installation. An external heating signal from a 230 V relay can control the heating medium for the LPHW coil. Additionally, a 2-way valve and a 230 V on/off actuator are available as accessories. Built-in water-cooled condenser (WCC) The new titanium water-cooled condenser offers improved performance and enhanced durability. When choosing this option, the WCC connections are relocated to the supply air side. MADE IN DENMARK Expanded control options The new controller offers a range of features and regulation options. The main display shows return air conditions and the operational status of the dehumidifier, with any active errors or alarms displayed immediately. Settings, setpoints, and configurable parameters can be accessed through the menu, including the option to enable external heating or cooling signals. For servicing, live data for all inputs and outputs is available, allowing technicians to clearly monitor dehumidifier variables. Initial configuration of the ducted CDP must be done via the 2.4-inch touch display, where you can set setpoints, enable heating/cooling, and adjust other settings. After configuration, a Dantherm remote controller can be connected to display room temperature and relative humidity. 3 Ducted swimming pool and industrial dehumidifiers CDP 85-135-175 CDP 85 The CDP 85-135-175 ducted condensation dehumidifiers are specifically designed for hotel, private, and therapy swimming pool hall dehumidification. They offer a great moisture removal per kWh, high durability, and efficient self-regulation. They are ideal for installation in an adjacent technical room. All metal parts and internal surfaces are powder coated before assembly and evaporator and condenser coils are made of epoxycoated aluminium. The corrosion protection is in accordance with EN/ISO 12944-2, class C4. The range is equipped with the Dantherm CC6 controller which comes with an integrated 2.4" touch screen for easy user customisation of setpoints and visualisation of operational variables. EC centrifugal constant flow fan User specified low and high air volume R454C refrigerant with GWP of 148 Movable inspection access Outdoor air inlet possibility (15%) through duct connection Supply air duct either horizontally or vertically connected Microchannel condenser Integrated control of exhaust fan and/or outdoor air damper Heat- and cooling demand regulation Datalogging and software update via supplied microSD card Compact unit designed to suit any plant room configuration Sandwich cover panels with 45mm insulation Optional water-cooled condenser Three setpoint specified control modes relative, absolute, or dew point Modbus RTU (RS485) Specifications Operating temperature range Operating relative humidity range Air flow, nominal Air flow, range Dehumidification capacity @ 30°C/60% RH Dehumidification capacity @ 20°C/60% RH Dehumidification capacity @ 30°C/60% RH*** Specific Energy Consumption (SEC)* Specific Energy Consumption (SEC)** Max. external pressure loss R454C gas weight/CO equivalent Power supply Power consumption, nominal air flow Current, max. @ 20°C/60% @ 30°C/60% Maximum Product size (w x d x h) Weight (w/o water-cooled condenser) Colour Units °C % RH m³/h m³/h l/24h l/24h l/24h kWh/l kWh/l Pa kg/t V/Hz kW A kW kW kW mm kg CDP 85 15-38 40-95 1,500 550-1,500 88 56 126 0,38 0,58 300 1,2/0,18 230/1ph/50 1,9 8,8 1,3 1,4 1,9 1155 x 725 x 650 140 RAL 9016 CDP 135 15-38 40-95 2,500 1,200-2,500 155 75 222 0,39 0,58 350 1,5/0,22 230/1ph/50 400/3ph/50 3,3 16,1 5,7 1,9 2,8 3,3 1300 x 900 x 850 230 RAL 9016 *30°C/60% RH @ nominal airflow **20°C/60% RH @ nominal airflow ***15% outdoor air w/ 9,0 g/kg MADE IN DENMARK 4 CDP 175 15-38 40-95 3,600 1,500-3,600 170 100 261 0,45 0,67 450 1,7/0,25 400/3ph/50 4,6 9,1 2,6 3,2 4,6 1400 x 1010 x 975 240 RAL 9016 Ducted swimming pool and industrial dehumidifiers CDP 85-135-175 Menu button Status field ON/OFF switch Room % RH Room °C Control panel The CDP series touchscreen control panel helps you set up and monitor the following - and more - parameters: Current and desired temperature Current and desired humidity Operational status indicator Menu access to a multitude of other settings On/off switch Accessories Heating coil water, internal Remote controller , wireless 2 way valve Valve actuator Temp/RH sensor, 10 meter cable Anti-vibration stands Wall brackets Performance data MADE IN DENMARK 5 Ducted swimming pool and industrial dehumidifiers CDP 85-135-175 Product dimensions 400 364 662 8 3 361 650 BOTTOM 143 159 FRONT Airflow direction 160 400 325 390 1155 81 365 425 729 8 0 362 TOP 400 279 424 560 8 3 850 400 452 837 MADE IN DENMARK BOTTOM 158 154 160 FRONT Airflow direction 400 452 1300 82 452 904 8 0 450 TOP 400 283 6 Ducted swimming pool and industrial dehumidifiers CDP 85-135-175 Product dimensions 636 8 3 975 500 932 BOTTOM FRONT Airflow direction 155 159 160 500 488 501 1400 82 507 1014 8 0 TOP 500 505 338 MADE IN DENMARK 7 DENMARK Dantherm Denmark A/S DK-7800 Skive +45 96 14 37 00 sales.dk@danthermgroup.com UNITED KINGDOM Dantherm Group Ltd Maldon CM9 4XD +44 (0)1621 856611 sales.uk@danthermgroup.com SWEDEN Dantherm Group AB 602 13 Norrköping +46 (0)11 19 30 40 sales.se@danthermgroup.com GERMANY Trotec GmbH 52525 Heinsberg +49 2452 962-0 vertrieb.de@danthermgroup.com 22844 Norderstedt +49 40 526 8790 sales.de@danthermgroup.com ITALY Dantherm Group S.p.A. 37010 Pastrengo (VR) +39 045 6770533 sales.it@danthermgroup.com SWITZERLAND Dantherm Group AG CH-5405 Baden Dättwil +41 43 500 00 50 sales.ch@danthermgroup.com FRANCE Dantherm Group SAS 69694 Vénissieux Cedex +33 4 78 47 11 11 67850 Herrlisheim +33 3 90 29 48 18 sales.fr@danthermgroup.com POLAND Dantherm Group Sp. z o.o. 62-023 Gdki +48 61 65 44 000 sales.pl@danthermgroup.com SPAIN Dantherm Group SP SAU 28108 Alcobendas, Madrid +34 91 661 45 00 46980 Paterna, Valencia +34 961 524 866 sales.es@danthermgroup.com NORWAY Dantherm Group AS 3138 Skallestad +47 33 35 16 00 sales.no@danthermgroup.com Dealer: KEEP UPDATED FOLLOW US ON: danthermgroup.com 09 2024