Samsung SWA-8500S Wireless Rear Speaker System Instruction Manual

1. Pengenalan

This manual provides essential information for the proper setup, operation, and maintenance of your Samsung SWA-8500S Wireless Rear Speaker System. This 2.0 channel speaker system is designed to enhance your audio experience by adding immersive surround sound to compatible Samsung Soundbars. Please read this manual thoroughly before using the product to ensure optimal performance and safety.

2. Maklumat Keselamatan

• Keselamatan Elektrik: Do not expose the unit to rain or moisture. Do not open the casing; refer all servicing to qualified personnel. Ensure the power cord is not pinched or walked on.
• penempatan: Place the speakers and wireless receiver module on a stable, level surface or securely mount them to a wall. Avoid placing near heat sources, direct sunlight, or in areas with excessive dust or vibration.
• Pengudaraan: Ensure adequate ventilation around the wireless receiver module to prevent overheating. Do not block ventilation openings.
• Pembersihan: Putuskan sambungan daripada kuasa sebelum membersihkan. Gunakan kain yang lembut dan kering. Jangan gunakan pembersih cecair atau semburan aerosol.

3. Kandungan Pakej

Sahkan bahawa semua komponen terdapat dalam kotak:

• Wireless Receiver Module (1)
• Rear Speakers (2)
• Speaker Cables (2)
• Power Cord for Wireless Receiver Module (1)
• Manual Arahan (dokumen ini)

4. Produk Lebihview

The Samsung SWA-8500S system consists of a wireless receiver module and two compact rear speakers designed to integrate seamlessly with compatible Samsung Soundbars.

Rajah 4.1: Berakhirview of the Samsung SWA-8500S Wireless Rear Speaker System, showing the two compact speakers and the central wireless receiver module.

Rajah 4.2: jarak dekat view of the wireless receiver module, featuring 'STANDBY' and 'LINK' indicators on the front panel.

Rajah 4.3: A single Samsung SWA-8500S rear speaker, illustrating its compact dimensions of approximately 3"D x 3"W x 5.7"H.

5. Persediaan

5.1 Connecting the Speakers to the Wireless Receiver Module

1. Kenal pasti pembesar suara kiri dan kanan.
2. Connect the speaker cables to the corresponding terminals on the back of each rear speaker and the wireless receiver module. Ensure correct polarity (red to red, black to black).
3. Position the rear speakers behind your listening area, typically to the left and right.

5.2 Pemasangan Dinding (Pilihan)

The speakers are wall-mountable. Use appropriate screws and wall anchors (not included) suitable for your wall type. Ensure the mounting location can support the weight of the speakers securely.

5.3 Pairing with a Compatible Samsung Soundbar

The SWA-8500S system must be paired with a compatible Samsung Soundbar. Refer to your specific Soundbar's instruction manual for detailed pairing instructions, as the process may vary slightly between models.

General Pairing Steps:

1. Plug in the power cord to the wireless receiver module and connect it to an electrical outlet. The LINK LED indicator on the module will blink blue.
2. Turn off your Samsung Soundbar.
3. On your Soundbar's remote control, press and hold the bisu butang (atau VOL button on some older models) for approximately 5-6 seconds until the "ID SET" message appears on the Soundbar's display.
4. The LINK LED on the wireless receiver module should turn solid blue, indicating a successful connection.
5. If the LINK LED continues to blink, repeat the pairing process.

Compatible Soundbar Models: HW-Q70R, HW-Q60R, HW-R650, HW-R550, HW-R450, HW-N400, HW-N450, HW-N550, HW-N650, HW-M360, HW-M450, HW-M4500, HW-M550, HW-Q60T, HW-T650, HW-S60T, HW-T550, HW-T450, T60M.

6. Operasi

Once paired, the SWA-8500S rear speakers operate in conjunction with your Samsung Soundbar. All sound adjustments, including volume and surround sound modes, are controlled via the Soundbar's remote control.

• Mod Suara: Ensure your Soundbar is set to a surround sound mode (e.g., 'Surround Sound' or 'DTS Virtual:X') to activate the rear speakers.
• Rear Level Adjustment: Use your Soundbar's remote to access sound settings and adjust the 'REAR LEVEL' to your preferred volume. This setting allows you to balance the rear speaker output with the front channels.

7. Penyelesaian masalah

If you encounter issues with your SWA-8500S system, refer to the following common solutions:

• No Sound from Rear Speakers:
  • Check if the wireless receiver module's LINK LED is solid blue. If blinking, re-pair the system (refer to Section 5.3).
  • Ensure speaker cables are securely connected to both the speakers and the wireless receiver module, checking for correct polarity.
  • Verify that your Soundbar's sound mode is set to a surround sound option.
  • Check the 'REAR LEVEL' setting on your Soundbar; it might be set too low.
• Bunyi Selang-seli atau Herotan:
  • Ensure the wireless receiver module is not obstructed and is within close proximity to the Soundbar.
  • Check for potential interference from other wireless devices (e.g., Wi-Fi routers, cordless phones). Try moving the module or Soundbar slightly.
• Kegagalan Berpasangan:
  • Confirm your Soundbar model is listed as compatible (refer to Section 5.3).
  • Ensure you are pressing the correct button on your Soundbar's remote for ID SET (often Mute, not VOL).
  • Unplug and replug the wireless receiver module, then retry the pairing process.

8. Spesifikasi

9. Waranti dan Sokongan

Untuk maklumat jaminan dan sokongan teknikal, sila rujuk kad jaminan yang disertakan dengan produk anda atau lawati Samsung rasmi website. You may also contact Samsung customer service for assistance with product registration, troubleshooting, and service requests.