MOONRAKER HLP-6 Halo Loop Folded Dipole Antenna
Moonraker 6 Metre 50 MHz Halo
Specifications
| SKU | 11-098 |
|---|---|
| Tuning Stub | RG-58 @ 300mm long, trim a couple of mm per cut, you should end around 265mm +/- |
Assembly Instructions
- Good starting point below, please try to keep each side equal.
- Overall length approx 34″ or 864mm.
- Insulator: 4″ or 102mm
- Fixing bracket: Ensure it is securely attached.
Connection Instructions
- A: This is the center bolt through the boom, connect the braid to this.
- B: This is the center core of your chosen coax, this connects to the driven arm. Please make sure they’re connected well and have no shorts. Then fit the cap.
Diagram Description
The diagram shows a rectangular antenna setup with insulators at each corner. The central section is labeled with points A and B, indicating connection points for the braid and coaxial cable. A fixing bracket is depicted at the bottom center of the structure.
Additional Information
We hope you have many QSO’s and wish you all the best in the hunt for DX, 73 The Moonraker team.
FAQ
- What is the purpose of the tuning stub?
- The tuning stub is used to adjust the length of the antenna for optimal performance, ending around 265mm +/-.
- How should I connect the coaxial cable?
- Connect the braid to point A and the center core to point B, ensuring no shorts and a secure connection.
- What is the overall length of the antenna?
- The overall length is approximately 34 inches or 864mm.
Documents / Resources
 | MOONRAKER HLP-6 Halo Loop Folded Dipole Antenna [pdf] Owner's Manual HLP-6, HLP-6 Halo Loop Folded Dipole Antenna, HLP-6, Halo Loop Folded Dipole Antenna, Folded Dipole Antenna, Dipole Antenna, Antenna |
