Monster Clarity 101 Airlinks true wireless bluetooth headset

Product specification

Product number : Monster Clarity 101 Airlinks
Drive unit : 6mm moving coil
Bluetooth version : 5.0
Waterproof coefficient : IPX5
Audio decoding : SBC、AAC
Charging performance of the charging compartment : DC 5.0V
Endurance : About 6 hours
The number of times the charging compartment recharges the headset : About 4th
Charging Time : Approximately 1 hour for earphones, 1.5 hours for charging box
Weight : 58g


Bluetooth pairing

  1. Take out the left and right earphones at the same time
  2. When you hear the “pairing” prompt (the blue indicator light is flashing), turn on the Bluetooth of the device to be connected and connect to “Monster Clarity 101 Airlinks”
  3. If the connection is successful, you will hear the “connected” prompt (the blue indicator flashes once in 6 seconds)
  4. Single ear mode: no need to re-pair

Reset method

  1. Please delete the Bluetooth connection record on the phone first
  2. Please take out the earphones, press both sides simultaneously for 8 seconds, the earphones will sound Power Off, come again there will be two beeps and the headset will automatically clear all pairing information.


  1. Switch on/off: Take out/put back the charging box
  2. Adjust the volume level: tap the left ear 2 times (down)/right ear 2 times (up)
  3. Switch tracks: Tap and hold the left ear for 2 seconds (top)/right ear for 2 seconds (bottom)
  4. Play/pause, answer/hang up: tap the left/right ear once
  5. Voice assistant (not during music playback): tap the left/right ear twice
  6. Reject the call: Long press the left/right ear for 2 seconds to reject the call

Monster Clarity 101 Airlinks User Manual – Download [optimized]
Monster Clarity 101 Airlinks User Manual – Download

Join the Conversation


  1. I lost the left ear piece and based on these instructions, I cannot pair the right earpiece with anything?
    Anyone have a work around?

  2. The left earpiece will not pair and seems to be disconnected from the right. I tried following instruction but have not been successful in resetting or repairing them. Any help would be appreicated.

  3. Doesn’t seem that factory reset is even possible with these headphones. The lack of instructions stating to hold for 8 seconds and “come again there will be two beeps” (which is super unspecific, and doesn’t work) probably means that there is no real way of factory resetting. Seems to be a lot of similar situations where one headphone will not sync. In my situation, both headphones want to act as separate bluetooth devices, making it impossible to connect both at the same time.

  4. I just found a solution to the factory reset, as the manual for these headphones is incorrect. The headphones need to be in the case, and the user needs to hold the top of the headphones for about 5 seconds.

Leave a comment

Your email address will not be published.