MONSTER 00050069 VPC Mongoos Joystick Bracket Instruction Manual

00050069 VPC Mongoos Joystick Bracket
Instruction Manual

Contents hide

1 GENERAL ASSEMBLY INFOS

2 HEX KEY SET WITH BALL HEAD + EXTENSION OR SIMILAR REQUIRED

3 BOLT DIMENSIONS AND HOW TO MEASURE THEM [mm]

4 ASSEMBLY

5 Documents / Resources

5.1 References

6 Related Posts

GENERAL ASSEMBLY INFOS

PROFILE NUT

HEX KEY SET WITH BALL HEAD + EXTENSION OR SIMILAR REQUIRED

BOLT DIMENSIONS AND HOW TO MEASURE THEM [mm]

ASSEMBLY

WARNING NOTICES
CAUTION! Do not clamp your fingers while attaching the bracket.
CAUTION! Check before usage if all screws are tightened.
DANGER: Contains small parts not suitable for children under 3 years.
Only suitable for children over 12 years and adults.
All MTSIM products are hand-assembled and quality-checked.
The mount is designed for usage only with a computer controller (f.e. joystick or throttle).
We exclude liability if the product is used for purposes other than intended.
MTSIM shall be liable for damage arising from causes other than the detriment to life, body and health only to the extent that such damage arises from wilful misconduct, gross negligence, or the culpable violation of a fundamental contractual obligation on the part of MTSIM or a vicarious agent (e.g. the delivery service) of MTSIM. Any further liability for damages shall be excluded.
If you have safety concerns or questions regarding assembly, contact us at info@mtsim.com or visit www.mtsim.com/en/