Owner's Manual for alpho models including: DPX Power Source Enclosure System, DPX, Power Source Enclosure System, Source Enclosure System, Enclosure System
DPX Power Source Enclosure System
DPX Power Source Enclosure System · Compact footprint ideal for ground mount installations in Right-of-Way for small cell applications · Provides power for up to 10 small cell nodes from a single grid tap connection · Wide AC input voltage range (90 to 305 Vac) for worldwide deployment · Type 3R rated outdoor cabinet with heat exchanger for improved energy efficiency and reduced maintenance costs · Optional energy storage enclosure available The DPX Power Source enclosure system is part of the distributed power transport product family specifically engineered using the new Alliance for Telecommunications Industry Solutions (ATIS) fault managed power distribution technology. The DPX Power Source enclosure system is housed in a Type 3R rated enclosure and designed for pole and ground mount installations. The enclosure system can remotely power up to 10 small cell nodes from a single grid tap connection. Optional energy storage cabinet is available to support additional backup time. Local and remote setup, adjustment and control is a simple single-step process with the system controller. By utilizing TCP/IP technology, complete configuration and monitoring of power equipment is possible through a network web browser or via local display. Distributed power transport architecture enables operators to deploy their network faster by eliminating the need to have AC utility power at each small cell location. At a central location, the central power hub converts the incoming AC power to fault managed power which is transported over a hybrid or copper only cable to a disconnect box and then to a down converter device located approximately 6000 ft away. This reduces installation and operating expenses, and provides flexibility related to site selection for the installation of the remote communications equipment 1 DPX Power Source Enclosure System Consult your Alpha® sales representative for system configurations. Electrical Input Voltage Input Frequency Power Factor THD Output Voltage Output Power Acoustic Features Protection Energy Storage Support Options Nominal: 208 to 277 Vac Operating: 187 to 305 Vac Extended: 90 to 187 Vac (derated power) 45.0 Hz to 66.0 Hz >95% (10 to 100% load) <5% (50 to 100% load) ±190 Vdc 10 × 2000 W channels <65 dbA ·Pad-lockable door handles ·1 x 20kA AC surge suppression ·10 x 20kA DC surge suppression · AlphaCap 665 for short duration backup of Cordex® CXC HP controller · PowerSafe® SBS 190F batteries installed inside PSE for backup, up to 5 channel outputs ·Energy storage enclosure for extended backup Mechanical Dimensions H × W × D Weight Mounting Cooling Environmental Temperature Relative Humidity Elevation Cabinet Rating Agency Compliance Safety Overall: 1232 × 1016 × 889 mm (48 × 40 × 35 in.) Footprint: 1232 × 1016 × 610 mm (48 × 40 × 24 in.) 180 kg (397 lb) ·Ground ·Pole (no battery application) 130 W/C (72 W/F) Heat Exchanger Operating: 40 to 46°C (40 to 115°F); plus solar loading Storage: 40 to 85°C (40 to 185°F) 5 to 95% non-condensing Up to 3,000 m (9,842 ft) Type 3R ·CSA-US Field Evaluation ·ATIS (Pending) ·CSA/UL 62368-1 (Pending) Cordex® CXC HP Controller DPX 5kW Bi-Directional Converter DPX 5kW Rectifier DPX 2kW Fault Managed Power Distribution Module with EnShieldTM Technology AlphaCap 665 Short Duration Backup Supply Module (optional) PowerSafe® SBS 190F Batteries (optional) EnerSys World Headquarters 2366 Bernville Road, Reading, PA 19605, USA Tel: +1-610-208-1991 +1-800-538-3627 EnerSys EMEA EH Europe GmbH, Baarerstrasse 18, 6300 Zug Switzerland EnerSys Asia 152 Beach Road, Gateway East Building #11-08, Singapore 189721 Tel: +65 6416 4800 © 2023 EnerSys. All rights reserved. Trademarks and logos are the property of EnerSys and its affiliates unless otherwise noted. Subject to revisions without prior notice. E.&O.E 09/2023 2 #0480092-00 REV AAdobe PDF Library 17.0 Adobe InDesign 18.5 (Macintosh)