Kupu Whakataki
Thank you for choosing the AMS 7207/1 Wall Clock Pendulum Clock. This manual provides essential information for the proper setup, operation, and maintenance of your new clock. Please read these instructions carefully before use and retain them for future reference.
Figure 1: AMS 7207/1 Wall Clock Pendulum Clock
Nga korero haumaru
- Ensure the clock is mounted securely to prevent falling and potential injury or damage.
- Puritia nga pākahiko kei taea e nga tamariki. Mena ka horomia, me toro atu ki te rongoa.
- Kaua e hanumi nga pākahiko tawhito me nga pākahiko hou, nga momo pākahiko rereke ranei.
- Tangohia ngā pākahiko mēnā kāore te karaka e whakamahia mō te wā roa hei ārai i te turuturu.
- Clean the clock with a soft, dry cloth. Avoid using abrasive cleaners or solvents.
Ihirangi mokete
Tena koa tirohia nga mea katoa kei roto i te kete:
- AMS 7207/1 Wall Clock Pendulum Clock
- Pukapuka Tohutohu (tenei tuhinga)
- Mounting hardware (screws, wall plugs - may vary by region)
Tatūnga
1. Te wetewete
Carefully remove the clock from its packaging. Inspect for any signs of damage. Retain packaging for future transport or returns.
2. Tāuta Pūhiko
- Locate the battery compartment on the back of the clock movement.
- Insert one (1) AA battery, ensuring the polarity (+/-) matches the indicators inside the compartment.
- Katia te uhi o te wahanga pākahiko.
3. Te Whakatakoto i Te Wa
Once the battery is installed, the clock will automatically search for the atomic time signal. This process may take several minutes. For manual setting:
- Use the small adjustment wheel or button on the back of the clock movement to manually set the time.
- Turn the wheel clockwise until the correct time is displayed.
Figure 2: Close-up of the clock dial
4. Tāutanga Pendulum
Gently attach the pendulum to the hook or slot provided on the clock movement. Ensure it hangs freely and can swing without obstruction.
5. Whakapiki i te Karaka
- Kōwhiria he wāhi tika mō te pakitara, kia tino pakari ai hei tautoko i te taumaha o te karaka.
- Mark the desired position for the mounting screw.
- Drill a pilot hole (if necessary) and insert a wall plug.
- Insert a screw, leaving a small portion protruding from the wall.
- Carefully hang the clock onto the screw, ensuring it is stable and level.
Nga Tohutohu Whakahaere
Timengawa
The AMS 7207/1 features a quartz pendulum movement with atomic operation. Once set up, the clock will maintain accurate time. The pendulum is for aesthetic purposes and should swing gently.
Atomic Time Synchronization
The clock automatically synchronizes with the atomic time signal, ensuring precise timekeeping. This feature also handles daylight saving time adjustments automatically. Ensure the clock is placed in an area where it can receive a clear signal, away from large metal objects or electronic interference.
Te tiaki
Te horoi
To clean the clock, gently wipe the surfaces with a soft, dry, lint-free cloth. For the glass, a slightly damp cloth followed by a dry one can be used. Avoid harsh chemicals or abrasive materials that could scratch the finish or glass.
Whakakapinga Pūhiko
When the clock hands stop moving or the pendulum stops swinging, it is time to replace the battery. Follow the battery installation steps in the Setup section. Always use a fresh AA battery.
Raparongoā
| Raruraru | Take pea | Rongoā |
|---|---|---|
| Karaka kaore e rere | Kua mate, kua hē ranei te whakauru i te pākahiko | Replace battery with a fresh AA battery, ensuring correct polarity. |
| He he te wa i whakaatuhia | Poor atomic signal reception or manual setting error | Move clock to a location with better signal. Allow time for synchronization. Manually set time if necessary. |
| Kāore te pendulum e piu ana | Not properly attached or obstructed | Ensure pendulum is correctly hooked and swings freely without touching the clock body. Check battery. |
Whakatakotoranga
- Waitohu: AMS
- Tau tauira: W7207/1
- Ahu: 62 x 7 x 294 cm (approx. 24.41"W x 9.06"H - Note: provided dimensions seem inconsistent, using product title's cm values)
- Taumaha: 1.1 Kirokaramu
- Rauemi: Massive walnut wood, lacquered with polished aluminum, satinated mineral glass
- Nekehanga: Quartz Pendulum Movement, Atomic Operation
- Momo Whakaatu: Tauritenga
- Puna Hiko: 1 x Pūhiko AA (kaore i whakauruhia)
- Tae: Silver (dial and hands), Brown (wood back)
- Whakamahinga o roto/waho: Roo-roto
Pūtāhui me te Tautoko
For warranty information and customer support, please refer to the documentation provided at the time of purchase or contact your retailer. You may also visit the official AMS webpae mo etahi atu awhina.
Kaihanga: AMS
Tau Waahanga Kaihanga: W7207/1