User Guide for GOOVER models including: 100W Triac Dimmable LED Driver, 100W, Triac Dimmable LED Driver, Dimmable LED Driver, LED Driver
GOOVER 100W Triac Dimmable LED Driver,Power Supply,AC 120V to DC 12V Transformer,Compatible with Lutron and Leviton Dimmers,for LED Lighting,ETL Certified
GOOVER USER GUIDE DIMMABLE LED DRIVER Forward phase, Magnetic low voltage and Triac Dimmers V1.2022.10 READ BEFORE INSTALLATION RISK OF SHOCK If direct wiring to a 120 volt circuit with an ac dimmer turn off power at circuit breaker before installing. Always connect (+) to positive and (-) to negative. Make sure positive never touches negative while powered. Allow ventilation, do not install in an airtight compartment. Cooler surrounding air temperatures extend driver life. Operate only within temperature range of 4°F (-20°C) to 104°F(40). Wiring must be in accordance with national & local electrical codes-low-voltageClass 2 circuit. Mount the driver flat to the surface to provide heat transfer for better cooling. It is normal for driver to feel warm to the touch, especially when under a full wattage load. For wire runs inside walls, use certified CL2 or better cabling and appropriate mounting hardware. Never connect 2 LED drivers to a single run of LED strips. Total wattage of LED fixtures connected to driver must not exceed wattage rating of this unit. If you don't know the wattage rating of your lighting, ask the manufacturer of your lighting. AVAILABLE FOR : 100W 120W Wiring Diagram 5 - YEAR WARRANTY Have any question, please contact us ! service@gooverlight.com Thanks for choosing Goover!Adobe PDF library 15.00 Adobe Illustrator(R) 24.0