CR1001F
Alarm Clock with Time Projection
CREATE YOUR PERFECT SLEEP ENVIRONMENT

Chapter 1 LOCATION OF CONTROLS

1.SET TIME BUTTON 2.HOUR BUTTON 3.MINUTE BUTTON 4.DIMMER/DST BUTTON 5.SNOOZE/OK BUTTON 6.ALARM 1 7.ALARM 2 8.ALARM ON/PAUSE 9.PROJECTION ON/FLIP/OFF 10.VOLUME+ BUTTON 11.VOLUME- BUTTON 12.AM INDICATOR

13.PM INDICATOR 14.ALARM 1 INDICATOR 15. ALARM 2 INDICATOR 16. DST INDICATOR 17. FOCUS RING 18. BATTERY COMPARTMENT 19. USB PORT 20. DC JACK 21.SPEAKER 22.HOLDER ( x 2pcs) 23. PROJECTION DIMMER

Chapter 2 POWERING ON

1. Install 2pcs 1.5V “AAA” size batteries to the proper terminals in the battery compartment to memorize the time/alarm setting in case of power outage.
   Note: Without AC power in, batteries don’t support time display ,but alarm will still goes off.
2. Connect the adapter line to DC jack , then plug into a 100~240V AC wall power outlet.

Chapter 3 TIME SETTING

1. Press button once, display starts flashing.
2. Press button to set the hour. press button to set the minute.
3. Press button to save time or wait for another 10 seconds to confirm automatically.
4. To change 12H/24H time format Hold press  to change 12H/24H time format.

Chapter 4 ALARM SETTING

1. Press button, the alarm indicator will light up, the display starts flickering.
2. Press button to set the hour, press button to set the minute.
3. Press button or button to save alarm time or just wait for another 10 seconds to confirm automatically.
4. Press button to adjust alarm volume.
5. Press  button to save volume setting.

Turn off Alarm
When alarm goes off:

1. Press button to temporarily turn off alarm for 9 minutes. Alarm will ring every next 9 minutes.
2. Press button or button to turn off alarm for 24 hours. The alarm indicator is still on, which means alarm is still activated and will ring after 24 hours.
3. When alarm is off, press button to active the alarm, setting will be the same as last time.
4. Cancel Alarm
   Hold press button until the alarm indicator will disappear from the display, the alarm will never goes off.

Chapter 5 PROJECTION MODE

1. Press projection mode button to turn on projection.
2. Press button once again to flip the projection reversely when the time projected backwards.
3. Press  once again to turn off projection.
   Note:
   
   1. Best projection distance is 1.5 to 3.0 meters (4.92 to 9.84 feet).
   2. Projector is a common LED light. So the projector is not visible in bright environment.
4. Rotate focus ring to adjust clarity of projection image.
   Note: if projection is fuzzy,please rotate the focus ring (17) to adjust angle for clear image.
   

Chapter 6 PROJECTION DIMMER

Press button to adjust the brightness of projection for
your preference.

Chapter 7 DIMMER & DST

Repeat press button to adjust the brightness of display for your preference.
Hold press button to switch DST function.

Chapter 8 USB CHARGING

Our projection clock has a USB Charger Port, which can chargeboth your phone or tablet at the same time.
The maximum charge current is 1 Ampere.

Contact our experts
support@mesqool.com
http://www.mesqool.com

Made in China
Version 3.0

Documents / Resources

mesqool CR01001F Alarm Clock with Time Projection [pdf] User Manual CR01001F Alarm Clock with Time Projection, CR01001F, Alarm Clock with Time Projection, Clock with Time Projection, Time Projection, Projection

References

• User Manual