MERCURY RT-N10E Wireless N150 Router

Asus RT N10E Fibre Setup

Using your own router? No worries, we’ve got you covered!

Log into the gateway:

1. Ensure your device is connected to the Router (preferably via cable)
2. Open a web browser
3. Type the following in the address bar at the top: 192.168.1.1
4. Default Username: admin
5. Default Password: admin

This should then give access to the router’s user interface

How to add correct settings for the Mercury network

From the left menu select: WAN. The Internet Connection page displays. Ensure the following settings are changed:

1. WAN Connection Type: PPPoE
2. Enable UPnP: Yes
3. Get the WAN IP automatically: Yes
4. Connect to DNS Server automatically: Yes
5. PPP Username: (your mercury acct number)@mercurybroadband.co.nz
6. Password: password123
7. Service Name: Leave blank
8. Connection Type: Continuous
9. MTU: 1492
10. Connect to DNS Server automatically: Yes
11. Select ISP: Manual
12. Internet: VID – 10, PRIO – 0
13. The rest can remain unchanged
14. Click: Apply

Documents / Resources

MERCURY RT-N10E Wireless N150 Router [pdf] Instructions RT-N10E, Wireless N150 Router, N150 Router, RT-N10E, Router

References

• User Manual