CANAMX365FE// OEM DIRECT FIT FRONT SPEAKER ENCLOSURES
CANAM MAVERICK X3
FITS 2017 AND UP CANAM MAVERICK X3 MODELS
MEMPHIS AUDIO DIRECT FIT OEM POWERSPORTS SPEAKERS
Memphis Audio direct fit OEM audio systems include everything you need to make your machine the loudest on the trails. These kits are designed to fit directly into your vehicle with zero custom fabrication required. Lightweight durable polypropylene speaker enclosures are tuned for maximum output and feature RGB LED lighting which illuminates the speaker cone, and Memphis badge and provides down lighting making your machine stand out from the crowd. All the components used in this kit are marine grade IP66 rated and designed to withstand water and the elements allowing you to bring the party wherever the trails take you.
BEFORE YOU BEGIN!
If you are uncertain about any aspect of this installation process check out the complete walk-through video in the link below:
WWW.MEMPHISCARAUDIO.COM/INSTALLATION-CENTER Memphis Audio recommends all installations be completed by a certiﬁed authorized Memphis Audio dealer.
This product has a 2-year warranty from the date of purchase for defects in material or workmanship. This warranty will be extended to 3 years when installed by a Memphis authorized dealer using Memphis Connection products. The warranty is void if the product has been physically damaged by improper usage or abuse. If repairs are attempted outside of a Memphis Audio facility, the warranty is void. This warranty is limited to the original retail purchaser and does not cover any expenses incurred in the removal or re-installation of the product. This warranty does NOT apply to product exterior and cosmetics. Memphis Audio disclaims any liability for incidental or consequential damages caused by product defects. Memphis Audio’s liability will not exceed the purchase price of the product and the warranty period specified.
What is NOT covered under the warranty
- Damage due to improper installation
- Damage caused by exposure to moisture, excessive heat, chemical cleaners and/or UV radiation
- Damage through negligence, misuse, accident or abuse. (Repeated returns for the same damage may be abuse)
- Product damaged in accident and/or due to criminal activity
- Service performed by anyone other than Memphis Audio
- Subsequent damage to other components
- Any cost or expense related to the removal or re-installation of product
- Products with tampered, missing, altered or defaced serial numbers/labels
- Freight damage
- The cost of shipping products to Memphis Audio
- Return shipping on non-defective items
- ny product not purchased from an authorized Memphis Audio dealer
Some states do not allow the exclusion or limitation of incidental or consequential damages. The above limitations or exclusions may not apply to you. This warranty gives you specific rights, you may have other rights which vary from state to state.
If warranty service is required, a return authorization number is required to return the product to Memphis Audio. Warranty shipments to Memphis Audio are the responsibility of the purchaser. Pack the product carefully in the original carton if possible Memphis Audio will not be responsible for damages incurred in shipment or due to improper packaging materials used by the purchaser.
If determined to be within warranty your product will be repaired or replaced at the discretion of Memphis Audio.
SPEAKER POD INSTALLATION
These instructions are designed to be used on 2017 and newer Canam Maverick X3 Models. These pods are designed specifically to work with these types of machines. If you have a different year or model machine, check with your authorized Memphis Audio dealer or contact Memphis Audio customer service at 800-489-2300 prior to attempting installation. These kits are not designed to be used with any other model or year vehicle. Attempting to install these speakers on any other vehicle may result in permanent damage to your vehicle.
DRIVER SIDE SPEAKER INSTALLATION
Remove the outside panels, there are eleven T30 bolts that need to be removed on each side to remove each fender.
NOTE: There are three T30 screws on the passenger side and two T30 bolts on the driver side that will have a 10mm bolt. Remove the metal clip that is securing the top panel to the fender.
Passenger Side Note: Use a flat head screwdriver to loosen the hose clamp on the gas tube. You will have to remove three additional T30 screws holding the top OEM speaker pod cover for access to the gas clamp.
Cut out the two templates provided with your kit along the green dotted line. Place the corresponding template as shown in the picture. Once you have the templates aligned, be sure to clearly mark the holes on the template using a scribe tool so that it can be seen after removing the template. Once the locations are marked, drill the 3 holes using a 1/4” drill bit. Use a 3/4” drill bit for the speaker wire hole.
SPEAKER POD INSTALLATION
After drilling your holes, you can place the brackets together as shown in the pictures using the two M5 screws provided in the hardware kit. Once both brackets are assembled you can then position the speaker pod on the inside of the vehicle so the three mounting points on the enclosure match up with the three 1/4” holes drilled into the plastic. Once these holes and enclosure mounting points are aligned, you can use the provided M6 screws and washers to secure your speaker pod tightly to the vehicle. Secure with M6 Screws and Washers Secure with M6 Screws and Washers
EXPAND YOUR SYSTEM WITH THESE ADDITIONAL PRODUCTS DESIGNED FOR YOUR MACHINE
MXAMCAPP APP CONTROLLED SOURCE UNIT
Need to control your audio system but don’t want to alter your dash? The MXAMCAPP App-controlled source unit gives you all the features and control of a traditional head unit directly from your phone or Bluetooth device. The black box hideaway unit is a fully functional Bluetooth streaming, AM/FM Radio with all the features of a traditional radio in a small IP66 rated marine grade package. o learn more visit www.memphiscaraudio.com or call us at 800-489-2300.
MXAMCAPP – Headless Unit
- 5 Source Options: AUX/BT/AM/FM/WB
- USB charging
- 50W x 4 built-in amplifier
- RGB LED control output
- Front/Rear/Subwoofer RCA output
- 5 Volt pre-amp output
- Conformal coated PCB IP66 Rated
- Wired remote fits standard rocker cutouts
- Wired remote buttons illuminate
CANAMX310SE POWERED 10” SUBWOOFER ENCLOSURE
Memphis Audio direct fit OEM Powered 10” subwoofer enclosures fit directly into your vehicle with zero custom fabrication required. The HDPE rotomolded subwoofer enclosures is extremely durable and tuned for maximum output and performance. The enclosure has a built-in marine-grade amplifier designed to pair perfectly with the 10” subwoofer to produce thunderous bass on the trails.
- 10” Memphis shallow subwoofer
- Powerful Internal 200W RMS/400W Peak amplifier
- Remote bass knob included
- IP66 rated
- Plug & Play Wire harness included
- Sealed connectors
- Designed specifically for your machine for easy installation
- HDPE (high-density polyethylene) rotational molded enclosure
Add to your system these rear Powersports pods. The kits include all the hardware needed to mount directly to your machine. These high-performance speakers are equipped with RGB LED lighting and are IP66 rated to withstand water and the elements. Contact your local Memphis Audio Dealer or contact us at 800.489.2300 to determine if you will need a bracket kit for your specific machine to mount these speakers.
|HIGH MOUNT BRACKET HOLE||HIGH MOUNT BRACKET HOLE|
|LOW MOUNT BRACKET HOLE||LOW MOUNT BRACKET HOLE|
|HIGH MOUNT BRACKET HOLE||LOW MOUNT BRACKET HOLE|
|HIGH MOUNT HOLE 1/4”||LOW MOUNT HOLE 1/4”|
CUT TEMPLATE ALONG THIS LINE
DRIVER SIDE TEMPLATE
|SPEAKER WIRE HOLE||BRACKET HOLE|
|BRACKET HOLE||BRACKET HOLE|
|SPEAKER WIRE HOLE 3/4”||BRACKET HOLE 1/4”|
CUT TEMPLATE ALONG THIS LINE
Documents / Resources
|MEMPHIS AUDIO CANAMX365FE OEM Direct Fit Front Speaker Enclosures [pdf] Instruction Manual|
CANAMX365FE, OEM Direct Fit Front Speaker Enclosures, CANAMX365FE OEM Direct Fit Front Speaker Enclosures, Fit Front Speaker Enclosures, Front Speaker Enclosures, Speaker Enclosures, Enclosures