ManyBox V503 Mini Projector

Package Include Product Function Structure Diagram

First Use

1. Plug the power cord to the projector.
2. Connect your device to the projector.
3. Press the power button to tum on the projector.
4. Select the input source.
5. Adjust here accordingly.
6. Press the power button twice to tum off the projector.
7. Adjust keystone and focus ring to get the best image performance. Adjust the keystone correction and focusing ring on the projector to obtain a satisfactory imaging effect.
   When keystone distortion occurs (see Figure 1 on the right), It Is recommended to adjust the keystone correction ring.
   When the image is blulT8d (see Figure 2 on the right), it is recommended to adjust the focusing ring to improve the clarity of the image.
   If satisfactory clarity cannot be achieved through adjustment, move the product forward or backward.

INPUT SOURCES

1. USB Connectionlnsert the USS flash driver lnlo the use port and choose the right single source then press play/pause button ton display to stop (press”sources” on the remote control or “S” on the panel than there is”inpu sources” on the screen choose ” USB).
2. sd card
3. HDMI ConnectionSupport most devices with HDMI a lot . Press “sources” on the remote control and choose the right  single  source”HDMI”
4. VGA Connection
   Connect the projector to a computer with a VAG cable (ont included)For Laptop or destopo computer.
5. DVD Connection
   Connect the DVD, DTV Tuner, etc with AV cable, choose the “AV” source input.For DVD Player, DTV Tuner, etc.

Projection Distance & Size

Multimedia Support Play FormatParameters

Important safety considerations

The following safety instructions ensure instruction the long service life of the projector to avoid fire or electric shock. Make  sure to  carefully read them and pay attention  to all the following warning.

• Do not install the projector in site with improper ventilation.
• Do not in1tall the projector in a hot and humid site.
• Do not block the ventilation holes (intake or exhau1t)
• Do not install the projector in dust and smoke sites.
• Do not install the projector near the temperature and smoke transducer.it may cause a sensor failure.
• Do not install the projector in sites with the direct blowing of the warm and cool air-conditioning wind. Otherwise, i1 may e-&ILIC the project failure due to moisture condensation or tempera tare increment.

FAQS

References

• User Manual