MELLANSEL Extendable Table Assembly
Product Overview
This document provides assembly instructions for the IKEA MELLANSEL extendable table.
Brand: IKEA
Model: MELLANSEL
Product Type: Extendable Dining Table
Design and Quality: IKEA of Sweden
Assembly Steps
Step 1: Prepare Tabletop
Place the tabletop upside down on a soft surface (e.g., a rug) to prevent damage.
Attach necessary hardware to the underside of the tabletop. This involves using 2x [screw] (Part ID: 103096).
A tool like a [hammer] may be required for this step.
Step 2: Extend Table
Extend the table by pulling the two halves apart.
Secure the extended sections using 2x [lock] mechanisms.
[Arrows] indicate the direction of extension.
Step 3: Insert First Extension Leaf
Insert one extension leaf into the central gap of the extended table.
[Arrow down] indicates the insertion direction.
Step 4: Secure Extended Table with Leaf
Extend the table further to accommodate the inserted leaf.
[Arrows] indicate the direction of extension.
Secure the table again using 2x [lock] mechanisms.
Note: Ensure correct part orientation and avoid incorrect assembly [cross symbol].
Step 5: Retract Table (with leaf)
To retract the table, first disengage the locking mechanisms.
Disengage 2x [lock] mechanisms.
[Arrow left] indicates the direction of retraction.
Step 6: Insert Second Extension Leaf
Insert the second extension leaf into the central gap.
[Arrow down] indicates the insertion direction.
Step 7: Extend Table Fully
Extend the table to its maximum length to accommodate both leaves.
[Arrows] indicate the direction of extension.
Step 8: Secure Fully Extended Table
Secure the fully extended table by engaging the locking mechanisms.
Engage 2x [lock] mechanisms.
Step 9: Retract Table (Partial)
To retract the table partially, disengage the locking mechanisms.
Disengage 2x [lock] mechanisms.
[Arrows] indicate the direction of retraction.
Step 10: Retract Table (Full)
Continue retracting the table to its original, shortest length.
[Arrows] indicate the direction of retraction.
Ensure all parts are correctly aligned and secured.
Step 11: Final State
The table is now in its retracted state.
[Info symbol] indicates general information or tips throughout the assembly.
Document Reference: AA-2566569-2
Copyright © Inter IKEA Systems B.V. 2024
