Kenwood Transceiver User Guide
This guide covers basic operations for Kenwood NX-5000, NX-3000, and NX-1000 series transceivers.
For detailed instructions, refer to the full manual at: https://manual.kenwood.com/files/B5K-1000-00.pdf
Specifications
| Model | Frequency Range | Max. Output Power | GPS | Bluetooth |
|---|---|---|---|---|
| NX-5700-E / NX-5800-E | 136.000 - 174.000 MHz (TX/RX) 400.000 - 470.000 MHz (TX/RX) | 25 W | ± 1575.42 MHz | 2402 - 2480 MHz |
| NX-3720-E / NX-3720G-E / NX-3820-E / NX-3820G-E | 136.000 - 174.000 MHz (TX/RX) 400.000 - 470.000 MHz (TX/RX) | 25 W | ± 1575.42 MHz | 2402 - 2480 MHz |
| NX-1700-E / NX-1800-E | 136.000 - 174.000 MHz (TX/RX) 400.000 - 470.000 MHz (TX/RX) | 25 W | ± 1575.42 MHz | 2402 - 2480 MHz |
Supplied Accessories
Carefully unpack the transceiver. Verify the contents against the list below before discarding packing material. If items are missing or damaged, contact the carrier immediately.
- DC power cable with fuses (15 A)
- DC power cable with fuses (10 A)
- Mounting bracket
- Microphone
- Microphone hanger
- 4 x 16 mm self-tapping screws (3)
- 5 x 16 mm self-tapping screws (4)
- M4 x 6 mm hex-headed screws with washers (4)
- Spring washers (4)
- Flat washers (4)
- User guide (1)
Basic Operation
Front Panel Description
The front panel of the transceiver typically includes the following components:
- Display: Shows operational status, channel information, and messages.
- Illumination Sensor: Adjusts display brightness based on ambient light.
- Status Indicator: Visual indicator for transmit, receive, or other operational states.
- Speaker: Outputs audio for received signals and alerts.
- Operation Buttons: Programmable buttons for various functions.
- Microphone: Input for voice transmission.
- PTT (Push-to-Talk) Switch: Located on the microphone; press to transmit, release to receive.
Power Switching
Press the power button [Power Symbol] to switch the transceiver ON. Press the power button [Power Symbol] again to switch it OFF.
Adjusting the Volume
Press the button programmed as [Volume Up] to increase the volume. Press the button programmed as [Volume Down] to decrease the volume.
Selecting a Zone and Channel
Use the buttons programmed as [Zone Up]/[Zone Down] and [Channel Up]/[Channel Down] to select the desired zone and channel.
Transmitting
- Select the desired zone and channel.
- Press and hold the PTT switch on the microphone. Speak into the microphone.
- Release the PTT switch to receive.
For optimal sound quality, hold the microphone approximately 3-4 cm (1.5 inches) from your mouth.
Receiving
Select the desired zone and channel. If signaling is programmed for the selected channel, you will hear a call only when the received signal matches your transceiver's settings.
Software License Information
This transceiver utilizes software governed by specific license agreements, including zlib, libpng, and Md5 licenses. These licenses grant permission for use, modification, and redistribution under specified terms, ensuring proper attribution and preventing misrepresentation of the original software.
