ELCOP PBD350VA Push Button Dimmer Instruction Manual

AU-PBD350VA-最新说明书

Push-Button-Dimmer-Green-PBD350VA-Instruction-Manual

Index of /wp-content/uploads/2021/02/

INSTRUCTION MANUAL Push Button Dimmer PBD350VA

NOTE: • The LED dimmer series are designed for One-Way operation as above diagrams. • More than one dimmers cannot be connected in parallel or series to control the same load from two different locations.

Original Document

If the viewer doesn’t load, open the PDF directly.

Extracted Text

INSTRUCTION MANUAL Push Button Dimmer
PBD350VA
Technical Data

Operating Voltage Frequency Maximum Load Minimum Load Dimming Mode
Control Method
Dimmable LED lamps
LV Halogen lighting with electronic transformers Incandescent lighting, MV Halogen lamps

220-240 Vj 50 Hz 350 W 10 W Trailing Edge One way 10-150W
10-350VA
10-350VOABS!

Function
a) Minimum Brightness If an LED or CFL lamp becomes unstable at low dimming levels , it can flicker or pulse on/off. The dimmer's minimum brightness can be set to a level above the point at which a lamp flickers or pulses.
1Remove the top tap. 2Hold down programming button until LED slow flashing. 3Hold down the button to the setting level. 4Double press the button to exit programming mode. b) Maximum Brightness The maximum brightness level provided by the dimmer can be set to suit customer requirements. 1Remove the top tap. 2Hold down the programming button when LED start slow flashing then press
the button again the LED will start quick flashing. 3Hold down the button to the setting level. 4Double press the button to exit
programming mode. c) LED Indicator The blue led indicator will be on when the dimmer is on. d) Memory Dimmer The dimmer has the option to turn on at the brightness level set when the lights were turned off/on at the last setting brightness. e) Protection: Overload, short-circuit, over current, over temperature protection.
Installation

The installation must be carried out by an electrician
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES. Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician.

L Switch
N

Dimmer

Load

NOTE: � The LED dimmer series are designed for One-Way operation as above diagrams. � More than one dimmers cannot be connected in parallel or series to control the same load from two different locations. � Dimmer Mechanism wiring is NOT polarity sensitive.