Installation Guide: ALT-YD-FR98-LED-(AII)

Tools Needed

• [screwdriver] Phillips screwdriver

Installation Steps

1. Remove (2x) phillips screws.

   [Image: Close-up of a hand using a screwdriver to remove two screws from the edge of a vehicle's tail light housing. Red arrows indicate the screw locations.]

2. Remove (2x) outer phillips screws.

   [Image: Close-up of a hand using a screwdriver to remove two screws from the outer edge of the tail light housing. Red arrows indicate the screw locations.]

3. Unseat tail light.

   [Image: A hand is shown gently pulling the tail light assembly away from the vehicle's body, indicating it is being unseated.]

4. Disconnect Brake and reverse light harness.

   [Image: A hand is shown disconnecting the electrical wiring harness connector from the back of the tail light assembly.]

5. Remove brake and reverse light sockets.

   [Image: Close-up of the back of the original tail light assembly, showing the brake and reverse light sockets being removed.]

6. Remove brake bulb from socket and insert Spyder socket insert into brake socket. (Make sure to align black wire of socket to black wire of socket insert)

   [Image: A hand is shown removing a bulb from a socket and then inserting a new Spyder socket insert into the brake light socket. The alignment of wires is emphasized.]

7. Install reverse socket onto Spyder tail light.

   [Image: A hand is shown installing the reverse light socket into the designated position on the new Spyder LED tail light assembly.]

8. Connect brake and reverse harness to Spyder tail light.

   [Image: The vehicle's electrical harness connector is shown being plugged into the corresponding connector on the new Spyder tail light assembly.]

9. Seat Spyder tail light.

   [Image: The new Spyder tail light assembly is shown being aligned and pressed back into its correct position on the vehicle's body.]

10. Reinstall (2x) outer screws and (2x) inner screws.

    [Image: Hands are shown using a screwdriver to reinsert the outer and inner screws, securing the newly installed tail light.]

11. Turn on lights and confirm all functions are working properly. You have successfully completed the install of your new Spyder LED tail lights.

    [Image: The rear of the vehicle is shown with the new Spyder LED tail lights illuminated, demonstrating their functionality.]

Further Assistance

For further help with installation, please watch our installation video. Follow the direct link below to our YouTube channel for more information:

http://www.youtube.com/watch

Disclaimer

Spyder Auto Installation Guide is not liable for damages, injuries, and death while installing the product. This is intended to be an installation guide, to reduce installation time. Spyder Auto has no responsibility for improper installation. If you do not know how to install, please have a professional install it.