NETGEAR Nighthawk M3 5G Mobile WiFi Hotspot Quick Start Guide

Getting Started

This guide provides instructions for setting up your NETGEAR Nighthawk M3 5G Mobile WiFi Hotspot.

For detailed instructions on alternative setup methods, including fixed installation, please visit NETGEAR.com/m3usermanual.

For regulatory compliance information, including the EU Declaration of Conformity, visit NETGEAR.com/about/regulatory/.

Important: Please review the regulatory compliance document before connecting the power supply.

Important Usage Information

Applicable to 6 GHz devices only:

• Only use the device indoors.
• Operation of 6 GHz devices is prohibited on oil platforms, cars, trains, boats, and aircraft.
• Operation of this device is permitted in large aircraft while flying above 10,000 feet.
• Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.

Package Contents

• Nighthawk M3 5G Mobile WiFi Hotspot
• USB cable
• Battery

To purchase a power adapter, Ethernet dongle, or additional battery, scan the QR code or visit NETGEAR.com/mobileaccessories.

Installation Steps

1. Remove Battery Cover

Locate the small indent on the corner of the back cover and gently pry it open.

2. Install the SIM and Battery

1. Slide the nano SIM card into its slot.
2. Insert the battery into the device.
3. Press to snap the back cover into place.

Set Up Your Mobile WiFi Hotspot

Press and hold the Power/navigation button for two seconds to turn on your hotspot. Follow the onscreen instructions to complete setup.

Power/navigation button:

• Press and hold to power up.
• Press to wake/navigate.

Alternatively, connect to the hotspot's default WiFi network with a WiFi device and visit http://192.168.1.1 to complete setup from the web.