Product Specifications
| d [mm] | d₀ [mm] | Installation Torque (Tinst) |
|---|---|---|
| M5 | d₀: 13–14mm | 3 Nm |
| M6 | d₀: 13–14mm | 3 Nm |
| M8 | d₀: 18–19mm | 3 Nm |
Installation Instructions
Drill a hole with diameter d₀ to the specified depth.
Diagram shows a drill bit of diameter d₀ and a hole depth indicator.
Insert the Hilti HTB-3 anchor into the pre-drilled hole.
Diagram shows the anchor being inserted into the hole.
Use the setting tool to expand the anchor within the hole.
Diagram shows the setting tool being used to expand the anchor.
Gently pull the anchor outwards to ensure it is seated.
Diagram shows the anchor being pulled outwards.
Confirm the anchor is fully expanded and secure. [Important!]
Diagram shows a close-up of the expanded anchor, with an exclamation mark.
Remove the setting tool and discard any waste material.
Diagram shows the setting tool being removed and waste material being collected.
Attach the fixture and tighten the nut to the specified installation torque of 3 Nm using a torque wrench.
Diagram shows a torque wrench tightening a nut to 3 Nm.
Minimum Clearances
Edge Distance: Minimum 60 mm
Spacing: Minimum 12.5 mm
Edge Distance (Alternative View): Minimum 60 mm, Maximum 76 mm
