Instruction Manual for DENSO models including: BABTN0035B, TN0035B, TN0035B Car Audio Stereo Unit, Car Audio Stereo Unit, Audio Stereo Unit, Stereo Unit, Unit
DENSO TEN Limited TN0035B BABTN0035B BABTN0035B tn0035b
File Info : application/pdf, 6 Pages, 535.86KB
DocumentDocument(Type A) TN0035B Operation Manual Model name Model No Car Audio TN0035B Index 1-Rating 2-Button Function Spec 3-Radio operation procedure 4-Operating manual (Bluetooth/Handsfree) 5-FCC Operating manual Requirement Page 2P 3P 4P 5P 6P (1/6) 1-Rating (Type A) RATED VOLTAGE LOAD IMPEDANCE BACK UP CURRENT RATED CURRENT AM TUNING RANGE FM TUNING RANGE DAB TUNING RANGE 12.0V (10.516.0V) - ground 4 2.1mA or less 4.0or less (Vcc=13.2V, 0.5W output) 531 - 1602 kHz (9kHz step) 87.5 - 108 MHz (100kHz step) 174.928 - 229.072 MHz (2/6) 2-Button Function Spec (Type A) 1 2 3 4 5 AUDIO controls Button No. Button Name POWER BACK HOME/TALK VOL DOWN VOL UP Operation Audio ON/OFF Transition to previous screen Short Push: Transition to home screen Long Push: AA/CP voice recognition Short Push: Decrease Volume Down 1 step Long Push: Decrease Volume Down continuously Short Push: Increase Volume Up 1 step Long Push: Increase Volume Up continuously (3/6) 3-Radio operation procedure [Operation procedure] (ACC-ON) ACC-ONTOYOTA After the ACC-ON, confirm that Toyota screen is displayed. "CAUTION" The screen is changed to "CAUTION" screen after a few seconds. *ACC-ON Note: It takes a little longer for the first time of ACC-ON. "Continue"MENU Press the "Continue" button on the face panel after a few seconds to move MENU screen. POWER Menu Screen Display "FM1 " Press the POWER button. When the Radio Mode Window on the screen is pressed,"FM1" screen is displayed. Press anywhere in this area "<" ">" SEEK Confirm that the screen is changed as below, Please push down the "<"button or ">"button. This will start to SEEK. Push this button AM/DAB Same as AM/DAB mode. (Type A) (4/6) 4-Operating manual (Bluetooth/Handsfree) [Operation procedure] (ACC-ON) ACC-ONTOYOTA After the ACC-ON, confirm that Toyota screen is displayed. "Add Device" Please press the "Add Device" button of the screen (Type A) "CAUTION" The screen is changed to "CAUTION" screen after a few seconds. *ACC-ON Note: It takes a little longer for the first time of ACC-ON. Push this button "Search Device" Please press the "Search Device" button of the screen "Continue"MENU Press the "Continue" button on the face panel after a few seconds to move MENU screen. Push this button BluetoothiPhone iPod) Confirm if screen is changed as below, Please set iPhone or iPod in pairing mode. Push this button Menu Screen Display "Setting"SETTINGS Please press the "Setting" button on the face panel to move to Settings screen Push this button Displays when you have more than one pairing equipment iPhoneiPod Select the iPhone or iPod to connect. "Settings""Bluetooth" Confirm if "Settings" screen is displayed, select the "Bluetooth" button on the display. Push this button Operate the phone after the message on the screen "Connection Completed" "Connection Completed" is displayed if completed. (5/6) (Type A) 5-FCC Operating manual Requirement CAUTION: Radio Frequency Radiation Exposure This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated with at least 20cm and more between the radiator and person's body in normal use position. Co-location: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. (6/6)Microsoft Excel for Microsoft 365