Bloomfold Dehumidifier
Model Number: BF001
Warnings
Safety precautions before use:
- Read the instructions before use.
- This product is intended for the intended use only.
- Always observe precautions when using the Dehumidifier.
- Ensure that the packaging material does not get into the hands of children. They may suffocate in it.
- Contains fluorinated greenhouse gases covered by the Kyoto Protocol.
- Do not place the product in an unventilated space smaller than 4 m².
- Leave at least 30cm of ventilation space around the product.
- Product designed only for R-290 (propane) gas as refrigerant. Comply with national legislation and do not release refrigerant into the atmosphere.
- R-290 (propane) gas is flammable and heavier than air. If a leak is suspected, evacuate and ventilate the room immediately. Then inform fire brigade of propane leak.
- Water collected is not suitable for drinking or watering plants. This can be a potential health risk.
- The product only works in rooms between 5 °C and 35 °C degrees Celsius.
- Use the product only for purposes in this manual. The product is designed for private household use.
- If the product or cord is damaged or does not function properly, do not use it and contact customer service.
- Remove plug only when product is off.
- Do not tilt the product. If the product is tilted more than 45° degrees, leave it upright for at least 24 hours before use.
- Empty the water tank before use.
- Keep product out of reach of children.
- Caution: Improper use may result in injury.
- Avoid getting the product or cord wet.
- Do not place objects on the dehumidifier.
- Place the dehumidifier on a flat, stable surface.
- Do not use the product near a bath or shower.
- Do not use the unit in a potentially explosive environment.
- Keep the product away from heat, hot surfaces and open flames.
- Remember that refrigerants are odourless.
- The product is not suitable for drying insulation material.
- Unplug the product before repair or cleaning.
- Do not disassemble the product.
- Check that the mains power matches your power supply.
- Always use the product on a grounded indoor 220-240V - 50/60Hz outlet.
Product Details
The Bloomfold Dehumidifier BF001 features several key components:
- 1. Controls: The main control interface.
- 2. Indication light: Displays operational status and humidity levels.
- 3. Front shell: The front casing of the unit.
- 4. Wheels: For easy mobility.
- 5. Air vent/outlet: Where dehumidified air is expelled.
- 6. Air filter: Filters air before it enters the dehumidifier.
- 7. Water level indicator: Shows the current water level in the tank.
- 8. Back shell: The rear casing of the unit.
- 9. Drainage: Port for continuous water drainage via a hose.
- 10. Water tank: Collects condensed water.
Diagram Description: A line drawing shows the front and back views of the dehumidifier, with numbered labels pointing to specific parts like controls, air vents, filter, water tank, and wheels.
User Manual / Instructions for Use
Follow these steps for proper setup and operation:
- Place the product in a ventilated area larger than 4m² and ensure at least 30 cm of ventilation space around the product.
- Ensure all ventilation holes are clear and not blocked.
- Do not place the product near a bath, shower, or standing water.
- The product operates within a temperature range of 5 °C to 35 °C.
Control Panel
The control panel includes the following buttons:
- POWER (⏻): Turns the unit on or off. Default fan speed is high, default humidity is 50%. If the power light flashes red, the unit is in defrost mode.
- MODE (⚙️): Selects operating modes:
- Auto Mode: Activates when room humidity is 3% above the set value.
- Continuous Drying: The unit runs constantly.
- Sleep Mode: Indicators dim after 10 seconds, ventilation reduces to low. Press any button to activate, press MODE again to deactivate.
- SPEED (?): Adjusts fan speed between fast and slow ventilation. Speed cannot be changed during continuous drying, defrost, or sleep modes.
- TIMER (⏱️): Sets a 0-24 hour timer for automatic on/off. Press to add 1 hour per press. Set to "00" to cancel.
- HUM SET (?): Sets the desired humidity level (30%-80% in 5% increments). The setting is confirmed after 3 seconds. Cannot be changed in Continuous Drying mode.
- LOCK (?): Press and hold for 3 seconds to activate child lock.
Functions
- Defrost Function: Automatically activates when ambient temperature drops below 18°C. The unit runs continuously for 45 minutes, followed by 10 minutes of defrosting in high ventilation mode.
- Dry Function: Activated by pressing POWER and then MODE until the top light illuminates.
Alarms
- Alarm Full Water Tank: When the water tank is full, an indicator light illuminates and the unit emits an alarm 5 times. Press any button to silence the alarm. The dehumidifier stops working until the tank is emptied.
Emptying the Water Tank
Manual Emptying
- Turn the product off using the POWER button.
- Remove the water tank and pour the water into a drain or container.
- Reinsert the water tank correctly.
- If the full tank indicator remains on, check the tank reinsertion and for blockages.
Continuous Draining
- Attach the drain hose and ensure it is free of blockages.
- Place the end of the hose into a sump or bucket.
- Verify that water flows freely.
Indication Light
The indicator light shows humidity levels:
- Blue: Humidity <45%
- Green: Humidity >45% - <65%
- Red: Humidity >65%
Cleaning & Maintenance
Clean the product with a slightly damp cloth; avoid abrasive cleaners. The filter should be cleaned every 2 weeks.
- Remove the filter grid and filter.
- Use a vacuum cleaner to remove dust. For heavy soiling, use a mild soapy water solution.
- Replace the filter grid and filter.
Diagram Description: Shows the filter being removed from the front of the dehumidifier, and then the filter being reinserted.
Troubleshooting
Problem | Solution |
---|---|
The device does not work | Check the socket and ensure the water tank is empty. The appliance does not work below 5°C or above 35°C. |
The device does not work properly | Clean the air filter as per the manual. Check the unit for blockages and remove them. |
No air enters the device | Clean the filter with a slightly damp cloth. |
The device makes a loud noise during operation. | The appliance is not on a flat stable surface or the filter is clogged. Wash the filter and place the appliance on a flat surface. |
E2 | Air sensor is broken, replace sensor. |
LO | The humidity is below 20%, the device turns off. |
HI | The humidity is above 90%, the unit turns off. |
CL/CH | The ambient temperature is not between 5 and 35 degrees Celsius, the device turns off. |
Storage
If the product will not be used for an extended period, follow these steps:
- Turn off the product and unplug the power cord.
- Empty the water tank and clean the filter. Allow the filter to dry completely.
- Store the dehumidifier indoors in a dry, ventilated area away from direct sunlight.
Specifications
Dimensions | 25.5 x 22.0 x 47.0 cm | Refrigerant type | R290, 55G |
---|---|---|---|
Weight | 11KG | Noise level | <40dB |
Material | ABS plastic | Working temperature | 5 °C and 35 °C |
Cord length | 1.5M | Working humidity | 20-90% |
Voltage | 220-240V | Min. surface | 4m² |
Rated power | 185W | Max. airflow | 125 m³/h |
Water tank | 2L | Timer | 0-24 hours |
Rated current | 1A | Maximum moisture removed | 12L / 24 hours |
Recycle
Think about the environment when recycling this device. Dispose of it at a responsible place designated by the local authority.