Introduction

This document contains the original instructions for your VEVOR Leather Bedroom Benches. Please read all manual instructions carefully before operating. VEVOR reserves the right to interpret its user manual. The appearance of the product is subject to the item you received. VEVOR will not provide advance notification for technology or software updates on its products.

Safety Instructions

WARNING:

Read this material before using this product. Failure to do so may result in serious injury.

Assembly Precautions:

1. Assemble only according to these instructions. Improper assembly may create hazards.
2. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly.
3. Keep the assembly area clean and well-lit.
4. Keep bystanders out of the area during assembly.
5. Do not assemble if tired or when under the influence of alcohol, drugs, or medication.
6. The product capabilities apply to properly and completely assembled products only.
7. Assemble on a flat, level, hard, and smooth surface capable of safely supporting the Leather Bedroom Benches.
8. If possible, use power tools to make assembly easier.
9. For additional information regarding the parts listed, refer to the Assembly Diagram in this manual. Unwrap and separate all parts in a clean work area.

Use Precautions:

1. Do not exceed specified weight capacities.
2. Use only on a flat, level, hard, and smooth surface that can safely support a fully loaded Leather Bedroom Benches.
3. Use as intended only.
4. Inspect before every use; do not use if parts are loose or damaged.

SAVE THIS MANUAL

Parts List

The following parts are included for assembly:

• Part A: Bench Seat (x1) - The main upholstered body of the bench.
• Part B: Legs (x4) - Four support legs, each with a mounting plate.
• Part C: Screws (x16) - M6*25mm screws for attaching the legs.
• Part D: Allen Wrench (x1) - Tool for tightening screws.

Spare Parts: Screws (Part C) (x2)

Assembly Steps

Step 1: Prepare Components

Place the bench seat (Part A) upside down on a protected surface. Identify the four legs (Part B) and the screws (Part C).

Step 2: Attach Legs

Align the mounting plates of each leg (Part B) with the pre-drilled holes on the underside of the bench seat (Part A). Ensure the legs are oriented correctly, following any directional marks. Secure each leg using four screws (Part C) and the provided Allen wrench (Part D). Tighten screws firmly.

Step 3: Final Check

Turn the assembled bench upright. Ensure all legs are stable and securely attached. The bench is now ready for use.

Product Parameters

* Products such as specifications, appearance, and design are subject to modification without prior notice.

Manufacturer and Importer Information

Manufacturer: Shanghaimuxinmuyeyouxiangongsi

Manufacturer Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai 200000 CN.

Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREET EASTWOOD NSW 2122 Australia

Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

EU Representative: E-CrossStu GmbH, Mainzer Landstr.69, 60329 Frankfurt am Main. [EC REP]

UK Representative: YH CONSULTING LIMITED. C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX [UK REP]