QUICK GUIDE

1. Installing into the car

Follow these steps to correctly install the BeSafe Stretch car seat into your vehicle.

Step 1: Side Impact Protection (SIP+)

Ensure the SIP+ element is correctly positioned on the side of the car seat facing the car door for enhanced side impact protection.

Step 2: Extend ISOFIX Connectors

Extend the car seat's ISOFIX connectors from the base of the seat.

Step 3: Connect to Vehicle ISOFIX Anchors

Align the ISOFIX connectors with the vehicle's ISOFIX anchor points and push them in until they click securely. Two green indicators confirm correct attachment. [✔️][✔️]

Step 4: Extend Support Leg

Extend the support leg downwards until it locks into place with an audible "Click!". Ensure the support leg is firmly on the vehicle floor. [✔️]

Step 5: Adjust Harness Height

Pull the harness adjustment strap to loosen the harness.

Step 6: Buckle Harness

Place the child in the seat and connect the two red buckle tongues into the buckle base.

Step 7: Tighten Harness

Pull the harness adjustment strap firmly to ensure the harness is snug against the child's body. [➡️]

Step 8: Attach Top Tether

Connect the top tether strap to the designated anchor point in your vehicle. [➡️]

Step 9: Secure Harness Buckle

Ensure the harness buckle clicks securely into place. [✔️]

Step 10: Final Harness Tightening

Perform a final tightening of the harness by pulling the adjustment strap.

2. Usage

Proper usage ensures optimal safety and comfort for your child.

Step 1: Adjust Harness Height

Adjust the harness height to fit your child's shoulders by pulling the harness adjustment strap.

Step 2: Release Harness

Press the harness release button [?] and open the buckle to allow the child to exit.

Step 3: Place Child in Seat

Position your child comfortably in the car seat.

Step 4: Position Harness Straps

Ensure the harness straps are positioned correctly over the child's shoulders.

Step 5: Tighten Harness

Pull the harness adjustment strap to achieve a snug fit.

Step 6: Adjust Recline Position

The seat offers 5 recline positions. Adjust as needed for your child's comfort. [⬆️][⬇️]

3. Removing from the car

Follow these steps to safely remove the car seat from your vehicle.

Step 1: Unbuckle Harness

Press the harness release button [?] and unbuckle the harness.

Step 2: Release ISOFIX Connectors

Activate the ISOFIX release levers (follow the sequence indicated by numbers 1 and 2) to detach the connectors.

Step 3: Retract ISOFIX Connectors

Retract the ISOFIX connectors back into the seat base.

Step 4: Retract Support Leg

Retract the support leg back into the seat base.

Step 5: Remove Seat from Vehicle

Lift the car seat out of the vehicle.