Nikon NIKKOR Z 24-50mm f/4-6.3 Lens

Introduction

Before using this product, please read these instructions carefully. You will also need to consult the camera manual. This lens is intended exclusively for use with mirrorless cameras featuring a Nikon Z mount.

For Your Safety

To prevent damage to property or injury to yourself or to others, read “For Your Safety” in its entirety before using this product. Keep these safety instructions where all those who use this product will read them.

A WARNING: Failure to observe the precautions marked with this icon could result in death or severe injury.

A CAUTION: Failure to observe the precautions marked with this icon could result in injury or property damage.

WARNING

• Do not disassemble or modify this product. Do not touch internal parts that become exposed as the result of a fall or other accident. Failure to observe these precautions could result in electric shock or other injury.
• Should you notice any abnormalities such as the product producing smoke, heat, or unusual odors, immediately disconnect the camera power source. Continued operation could result in fire, burns or other injury.
• Keep dry. Do not handle with wet hands. Failure to observe these precautions could result in fire or electric shock.
• Do not use this product in the presence of flammable dust or gas such as propane, gasoline or aerosols. Failure to observe this precaution could result in explosion or fire.
• Do not directly view the sun or other bright light source through the lens. Failure to observe this precaution could result in visual impairment.
• Keep this product out of reach of children. Failure to observe this precaution could result in injury or product malfunction. In addition, note that small parts constitute a choking hazard. Should a child swallow any part of this product, seek immediate medical attention.
• Do not handle with bare hands in locations exposed to extremely high or low temperatures. Failure to observe this precaution could result in burns or frostbite.

CAUTION

• Do not leave the lens pointed at the sun or other strong light sources. Light focused by the lens could cause fire or damage to product’s internal parts. When shooting backlit subjects, keep the sun well out of the frame. Sunlight focused into the camera when the sun is close to the frame could cause fire.
• Do not leave the product where it will be exposed to extremely high temperatures, for an extended period such as in an enclosed automobile or in direct sunlight. Failure to observe this precaution could result in fire or product malfunction.
• Do not transport cameras or lenses with tripods or similar accessories attached. Failure to observe this precaution could result in injury or product malfunction.

Notice for Customers in Europe

This symbol indicates that electrical and electronic equipment is to be collected separately. The following apply only to users in European countries:

• This product is designated for separate collection at an appropriate collection point. Do not dispose of as household waste.
• Separate collection and recycling helps conserve natural resources and prevent negative consequences for human health and the environment that might result from incorrect disposal.
• For more information, contact the retailer or the local authorities in charge of waste management.

Using the Lens

Parts of the Lens: Names and Functions

Refer to the diagram on the upper left edge of this sheet.

• q Lens hood mounting mark: Use when attaching the lens hood.
• w Zoom ring: Rotate to zoom in or out. Be sure to extend the lens before use.
• e Focal length scale: Determine the approximate focal length when zooming the lens in or out.
• r Focal length mark
• t Control ring: In autofocus mode, rotate the ring to adjust a setting such as Focus (M/A) or Aperture assigned using the camera. In manual focus mode, rotate the ring to focus.
• y Lens mounting mark: Use when mounting the lens on the camera.
• u CPU contacts: Used to transfer data to and from the camera.
• i Lens hood*: Lens hoods block stray light that would otherwise cause flare or ghosting. They also serve to protect the lens.
• o Lens hood lock mark: Use when attaching the lens hood.
• !0 Lens hood alignment mark
• !1 Lens cap (front cap)
• !2 Lens cap (rear cap)

Attachment and Removal

Attaching the Lens

1. Turn the camera off, remove the body cap, and detach the rear lens cap.
2. Position the lens on the camera body, keeping the mounting mark on the lens aligned with the mounting mark on the camera body, and then rotate the lens counterclockwise until it clicks into place.

Removing the Lens

1. Turn the camera off.
2. Press and hold the lens release button while turning the lens clockwise.

Before Use

The lens is retractable and must be extended before use. Rotate the zoom ring as shown until the lens clicks into the extended position. Pictures can only be taken when the focal length mark points to positions between 24 and 50 on the focal length scale.

To retract the lens, rotate the zoom ring in the opposite direction, stopping when you reach the (●) position on the focal length scale. If the camera is turned on with the lens retracted, a warning will be displayed. Extend the lens before use.

Attaching and Removing the Lens Hood

Align the lens hood mounting mark with the lens hood alignment mark (q) and then rotate the hood (w) until the mounting mark is aligned with the lens hood lock mark (e). To remove the hood, reverse the above steps.

When attaching or removing the hood, hold it near the lens hood alignment mark (●) and avoid gripping the front of the hood too tightly. The hood can be reversed and mounted on the lens when not in use.

Using the Lens on Cameras with a Built-in Flash

Shadows will be visible in photos where the light from the built-in flash is obscured by the lens or lens hood. Remove the lens hood before shooting.

When the Lens Is Attached

The focus position may change if you turn the camera off and then on again after focusing. If you have focused on a pre-selected location while waiting for your subject to appear, we recommend that you do not turn the camera off until the picture is taken.

Precautions for Use

• Do not pick up or hold the lens or camera using only the lens hood.
• Keep the CPU contacts clean.
• Replace the lens caps when the lens is not in use.
• To protect the interior of the lens, store it out of direct sunlight.
• Do not leave the lens in humid locations or in locations in which it may be exposed to moisture. Rusting of the internal mechanism can cause irreparable damage.
• Do not leave the lens next to open flames or in other extremely hot locations. Extreme heat could damage or warp exterior parts made from reinforced plastic.
• Rapid changes in temperature may cause damaging condensation inside and outside the lens. Before taking the lens from a warm to a cold environment or vice versa, place it in a bag or plastic case to slow the change in temperature.
• We recommend that you place the lens in its case to protect it from scratches during transport.

Lens Care

• Removing dust is normally sufficient to clean the glass surfaces of the lens.
• Smudges, fingerprints, and other oily stains can be removed from the lens surface using a soft, clean cotton cloth or lens cleaning tissue lightly dampened with a small amount of ethanol or lens cleaner. Wipe gently from the center outwards in a circular motion, taking care not to leave smears or touch the lens with your fingers.
• Never use organic solvents such as paint thinner or benzene to clean the lens.
• Neutral Color (NC) filters (available separately) and the like can be used to protect the front lens element.
• If the lens will not be used for an extended period, store it in a cool, dry location to prevent mold and rust. Do not store in direct sunlight or with naphtha or camphor moth balls.

Accessories

Supplied Accessories

• LC-52B Lens Cap (front cap)
• LF-N1 Lens Cap (rear cap)

Compatible Accessories

• HB-98 Lens Hood
• CL-C4 Lens Case
• 52 mm screw-on filters

Filters

• Use only one filter at a time.
• Remove the lens hood before attaching filters or rotating circular polarizing filters.

Specifications

Nikon reserves the right to change the appearance, specifications, and performance of this product at any time and without prior notice.

Warranty Information

Warranty Terms

Your Nikon equipment is guaranteed against any manufacturing defects for one full year from the date of original purchase. If during this period of guarantee the product proves defective due to improper material or workmanship, our authorized service network within the sales territory of Nikon Europe B.V. will, without charge for labor and parts, repair the product in the terms and conditions set as below. Nikon reserves the right (at its sole discretion) to replace or repair the product.

1. This warranty is only provided upon presentation of the completed warranty card and original invoice or purchase receipt indicating the date of purchase, product type and dealer’s name, together with the product. Nikon reserves the right to refuse free-of-charge warranty service if the above documents cannot be presented or if the information contained in it is incomplete or illegible.
2. This warranty will not cover:
   
   • necessary maintenance and repair or replacement of parts due to normal wear and tear.
   • modifications to upgrade the product from its normal purpose as described in user manuals, without the prior written consent of Nikon.
   • transport costs and all risks of transport relating directly or indirectly to the warranty of the products.
   • any damage resulting from modifications or adjustments which may be made to the product, without the prior written consent of Nikon, in order to comply with local or national technical standards in force in any other country than the ones for which the product was originally designed and/or manufactured.
3. The warranty will not be applicable in the case of:
   
   • damage caused by misuse including but not limited to failure to use the product for its normal purpose or according to the user instructions on the proper use and maintenance, and to installation or use of the product inconsistent with the safety standards in force in the country where it is used.
   • damage caused by accidents including but not limited to lightning, water, fire, misuse or neglect.
   • alteration, defacing, illegibility or removal of the model or serial number on the product.
   • damage resulting from repairs or adjustments which have been conducted by unauthorized service organizations or persons.
   • defects in any system into which the product is incorporated or with which it is used.
4. This service warranty does not affect the consumer’s statutory rights under applicable national laws in force, nor the consumer’s right against the dealer arising from their sales/purchase contract.

Notice: An overview of all authorized Nikon Service Stations can be found online by following this Link: https://www.europe-nikon.com/service/