200W USB-C 6-Port PD GaN Charger
Quick Guide
Getting Started
- 1
Connect the included C5 power cable to the C5 connector on the rear of the charger.
- 2
Plug the power cable directly into a power outlet ?.
- 3
The LED indicator light will illuminate white when receiving power.
- 4
The 200W charger can be laid flat horizontally on its supported rubber feet or vertically using the included Desktop Stand [Desktop Stand].
- 5
Plug in charging cables (sold separately) into the charger's USB-C PD ports. We always recommend using certified charging cables. EMARK cables are required to reach wattage above 60W.
- 6
Connect and charge up to six USB-C devices simultaneously. The total maximum output is 200W. When connecting devices to all six PD ports, connect your largest device to the PD1 port.
Charging Configurations
7 When connected to PD1 or PD2, a supported device can charge with a maximum output of 140W. Only one device can be connected at a time to either port to achieve 140W charging. A USB-C to MagSafe 3 Cable must be used to achieve 140W output through PD1 or PD2.
Diagram shows: PD1 (Max 140W) connected to MagSafe 3 [MagSafe 3 connector], PD2, PD3.
8 When connected to PD3 or PD4, a supported device can charge with a maximum output of 100W.
Diagram shows: PD2, PD3, PD4 (Max 100W), PD5.
9 When connected to PD5 or PD6, a supported device can charge with a maximum output of 20W.
Diagram shows: PD4, PD5, PD6 (Max 20W).
Technical Notes
- Standard operating temperature: 150°F / 65°C.
- Please refer to the Power Schematic in the user manual for actual power outputs, depending on the number of connected devices.
