BOSJÖN Kitchen Mixer Tap
Installation Guide
General Installation Requirements
[info] Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional.
Safety Precautions
[warning] Switch off the main shut-off valve before changing the mixer tap.
Technical Specifications
- Maximum recommended water temperature: 60°C (140°F)
- Maximum operating temperature: 80°C (176°F)
- Operating pressure range 1: 1-5 bar (0.1-0.5 MPa, 14.5-72.5 psi)
- Operating pressure range 2: 0.5-10 bar (0.05-1 MPa, 7.2-145 psi)
- Connection size: G1/2
Parts and Tools
The package typically includes the mixer tap body, flexible hoses, a mounting bracket, washers, a securing nut, and an Allen key. You will need a coin to unscrew the aerator and potentially a wrench (2x indicated in diagrams).
[info] Silicone sealant is required for sealing open surfaces to prevent water penetration, but it is not included.
Assembly Instructions
Step 1: Mounting the Tap
Insert the tap through the mounting hole in the countertop or sink. The recommended hole diameter is 34-37 mm (1 3/8 - 1 1/2 inches). The maximum countertop thickness is 50 mm (2 inches).
Diagram description: Shows the tap being inserted into a countertop hole, with dimensions and thickness limit indicated.
Step 2: Securing the Tap
From underneath the countertop, place the provided washers and secure the tap with the mounting nut. Tighten using the provided Allen key or a suitable tool.
Diagram description: Illustrates placing washers and a nut from below, and tightening with a tool.
Step 3: Connecting Hoses
[warning] IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.
Connect the flexible hoses to the tap and the water supply lines. Ensure all connections are secure but not overtightened.
Diagram description: Shows flexible hoses being connected to the tap and water supply, with a warning symbol and text about not overtightening.
Pre-Use Preparation
Before first use: Unscrew the aerator/flow guide with a coin. Allow water to run freely for a few minutes to flush out any debris. Screw the aerator/flow guide back into place until it stops. DO NOT OVER TIGHTEN.
Maintenance and Checks
[info] Check at regular intervals to make sure that the installation is not leaking.
