FollowMe GV20 Quick Installation Guide

Please carefully read the user guide before use in order to avoid damages and quickly get the device to operate. Product appearance, color and accessories are subject to change without prior notice in this manual.

Version 1.0
Updated: 4 March 2021

Contact us on 7901617 for any assistance required.
www.followme.mv, info@followme.mv

Product Specifications

CAUTION ⚠️

• Please connect DC power with correct Polarity. Incorrect polarity may damage the tracking device and voids warranty.
• Use Full / Large SIM for the device.
• Activate Prepaid SIMs before using for the device.
• Remove PIN number from SIM before using.

Installation Instructions

Open the Device

Note:
1. Please power off the device before install or remove the SIM card.

1. Open the cover
2. Insert the SIM card correctly

[Diagram: Device with power on/off switch, SIM slot, power indicator, GPS status indicator, GSM status indicator, and power cable connector labeled.]

Pull the lid to open the device

LED indicators

GPS LED Indicator - Blue

• Flashing (interval 0.1s): Searching BD/GPS signal
• Solid blue: BD/GPS positioned
• OFF: GPS sleep or off

GSM LED Indicator - Green

• Quick flashing: GSM initializing
• Slow flashing: Receive GSM signal normally
• Solid green: Connected to GPRS network
• OFF: No GSM signal or SIM card

Wiring

Vehicles

[Diagram: Wiring for vehicles showing connections for ACC ON, START, Ignition lock, Battery (+/-), and Fuse, with wire colors RED, BLACK, ORANGE, and YELLOW indicated.]

Boats

(If Engine start notification is required, follow Vehicle wiring – But Not recommended)

[Diagram: Wiring for boats showing connections for Battery (+/-), and Ignition, with wire colors RED, BLACK, ORANGE, and YELLOW indicated.]

Switch ON the device.

The tracking device switches ON automatically when connected to DC Power. But always make sure the Power on/off switch is at ON position. This will use internal battery to run the device, if external DC power fail.

Close the Cover

[Diagram: Device with light sensor and 3M cotton stick shown, indicating the light sensor should face down.]

Use the 3M cotton stick (provided) to fix the device. The light sensor should face down

[Diagram: Device fixed in position, with a note that incorrect position may reduce GPS signal.]

Fix the device as shown. Incorrect position may reduce GPS signal

Fixing the device on Boats

Speed Boats

[Diagram: A speed boat with the tracking device mounted at the highest location.]

Fishing Dhoni

[Diagram: A fishing boat with the tracking device mounted at the highest location.]

• Fix the tracking device at the highest location possible, inside the boat way from metal surfaces, electric wiring etc.
• A recommended location for speed boat is near the VHF set where the DC power is available (marked by a circle)
• Keep the tracking device face up for better GPS reception.

Cable Details