Congratulations!

PRIMING UNIT (FIRST TIME USE ONLY)

1. Fill reservoir with warm water and replace it firmly on the base. Insert tip firmly until it clicks into place.

   Diagram Description: Illustrates filling the water reservoir, attaching it to the base, and inserting the flosser tip into the handle until it clicks.

   Labels: [Fill], [Replace], [Insert]

2. Turn pressure to high, point tip into sink, turn power ON and water switch to ON until water flows. Turn power and water OFF.

   Diagram Description: Shows the unit with the pressure set to high, the tip aimed into a sink, and the power and water switches in the ON position, indicating water flow. The unit is then shown with power and water turned OFF.

   Labels: [Power On], [High]

WATER FLOSS

1. Place tip in mouth. Start on low pressure. Turn power ON. Turn water ON and increase pressure to your liking.

   Diagram Description: Depicts the water flosser tip inside the mouth, with the pressure dial set to low, and both power and water switches ON.

   Labels: [Power On], [Low], [Water On]

2. Lean over sink. Close lips enough to prevent splashing, while still allowing water to flow from mouth into sink. TO AVOID MESS: KEEP TIP IN MOUTH WHILE UNIT IS ON.

   Diagram Description: Shows a user leaning over a sink, with lips partially closed around the flosser tip to manage water flow into the sink.

3. Aim water at the gumline at a 90 degree angle. Follow the gumline and pause briefly between teeth.

   Diagram Description: Illustrates the water flosser tip angled at 90 degrees to the gumline, with water spraying. The tip pauses between teeth.

NEED HELP?

Visit Waterpik.com/WelcomeWF to watch a How To Video and find additional product support.

Call Us! 1-800-525-2774