Fogatti Wall Mounted Control User's Guide
This guide provides basic steps for operating the air conditioner. For detailed information on operating modes and special functions, refer to the operating instructions manual.
Operation
The control panel displays the current mode, room temperature, and set temperature. Users can adjust settings using the provided buttons. Temperature Range: 16°C - 31°C / 61°F - 88°F. To switch between °C and °F: Under the power-on state, press and hold the power button.
Mode Display
The display shows different icons for each operating mode:
- Cooling: Displays a snowflake icon.
- Heating: Displays a sun icon (available on models with heating function).
- Dehumidify: Displays a water droplet icon.
- Fan: Displays a fan icon.
Fault code & Function descriptions
| Fault condition | Digital display code | Note |
|---|---|---|
| Communication interruption of relay control module | E1 | 1. Check the dip switch. 2. Check the wire between power and controller. 3. Replace PCB or Controller. |
| Room temperature sensor is open or has different range | E2 | 1. Check temperature sensor connection. 2. Replace temperature sensor. |
| Room temperature sensor fault | E3 | 1. Check temperature sensor connection. 2. Replace temperature sensor. |
| Communication fault | C5 | 1. Check the wire between power and controller. 2. Replace PCB or Controller. |
Installation Instructions
Follow these steps for installing the wire controller:
- Step One: Remove the cover of the wire controller box.
- Step Two: Secure the back cover with screws.
- Step Three: Install two screws according to the drawing.
- Step Four: Attach the wire controller to the back cover. Installation is complete.
Remarks:
- After power-off and power-on or abnormal communication, re-operate the on-off button, or after setting the timing, or after waiting for three minutes, you can directly operate and adjust.
- The provided pictures are for reference only.
Wiring Diagrams
The document includes wiring diagrams for the electric control and wire controller, showing connections for power, sensors, and relays. It specifies using copper conductors only and notes the voltage as 115VAC 60Hz. A diagram illustrates the connection between the wire controller and the electric control unit, including temperature sensor and relay connections.
