SKOGSTA Chair
Assembly Instructions
Parts and Tools
Tools Required
- Screwdriver [tool-icon]
- Allen Key (included, part 10083377) [tool-icon]
Parts List
Part Number | Description | Quantity |
---|---|---|
10093115 | Bolt | 2x |
114575 | Bolt | 6x |
100842 | Washer | 6x |
100514 | Connector | 2x |
10083377 | Allen Key | 1x |
Assembly Steps
Step 1: Preparation
Place the chair seat upside down on a table. Use a protective cloth (e.g., a blanket or the packaging material) to prevent scratches on the seat surface.
Step 2: Attach First Three Legs
For each of the first three chair legs: Insert a bolt (part number 114575) through a washer (part number 100842). Pass this assembly through the designated hole on the underside of the chair seat and into the corresponding leg. Tighten using the included Allen key (part number 10083377). Important: Do not use bolt 10093115 for this step. The diagram shows bolt 10093115 with a cross mark [❌] and bolt 114575 with a check mark [✔️].
Step 3: Attach Remaining Legs
Repeat the process described in Step 2 for the remaining three chair legs. Ensure all six legs are securely attached and tightened.
Step 4: Install Crossbars
Insert the connectors (part number 100514) into the pre-drilled holes on the inside of the chair legs. Position a crossbar between two legs. Align the holes in the crossbar with the connectors. Insert bolts (part number 10093115) through the crossbar and into the connectors. Tighten using the Allen key (part number 10083377). Repeat this process for the second crossbar.
Step 5: Final Tightening
Perform a final check of all bolts and connections. Ensure everything is securely tightened for stability. The SKOGSTA chair is now assembled.