1. Refer to the Service Manual for the motorcycle, remove the motorcycle parts. TOOLS REQUIRED Hex wrench (5 mm) Torque wrench No. Description Qty (1) Meter visor 1 (2) Meter visor stay 1 (3) 5 mm socket bolt 4 (4) 5 mm thrust washer 4 (5) 5 mm well nut 4 (6) Rubber washer 4 (7) Washer 2 (8) Collar 2 (9) URL paper 1 Item N·m kgf·m lbf·ft
Refer to the Service Manual for the motorcycle, remove the motorcycle parts. TOOLS REQUIRED. Hex wrench (5 mm). Torque wrench. No. Description.
INSTALLATION INSTRUCTIONS Accessory METER VISOR P/N 08R74-K87-A30 Application After '19 CMX300/A CMX500/A Honda Dealer: Please give a copy of these instructions to your customer. Publication No. MII 17465 Issue Date March 2020 PARTS LIST (3) (4) (6) INSTALLATION NOTE: (1) · Take care not to damage the painted surfaces of the motorcycle. · Reinstall the removed parts on the motorcycle and make sure that wires and harnesses are not pinched. (8) (7) 1. Refer to the Service Manual for the motorcycle, remove the motorcycle parts. BOLT (5) (9) (2) No. Description Qty (1) Meter visor 1 (2) Meter visor stay 1 (3) 5 mm socket bolt 4 (4) 5 mm thrust washer 4 (5) 5 mm well nut 4 (6) Rubber washer 4 (7) Washer 2 (8) Collar 2 (9) URL paper 1 TOOLS REQUIRED Hex wrench (5 mm) Torque wrench TORQUE INFORMATION Tighten all screws, bolts, and nuts to their specified torque values. Refer to the Service Manual for the torque values of the removed parts. Item N·m kgf·m lbf·ft 5 mm socket bolt 1.0 0.1 0.7 FLANGE COLLAR (Save) 2. Refer to the Service Manual for the motorcycle, remove the motorcycle parts. · Repeat on the right side. NUT (Save) BOLT © 2020 Honda Motor Co., Ltd. - All Rights Reserved. 1 of 3 08R74-K87-A30 3. Loosely install the meter visor stay as shown. BOLT (Reuse) COLLAR 4. Loosely install the bolt as shown. · Repeat on the right side. BOLT (Reuse) WASHER METER VISOR STAY Motorcycle with the Accessory socket and this accessory. BOLT (Reuse) COLLAR METER VISOR STAY 5. Tighten all loosely bolts to their specified torque values. 6. Install the meter visor as shown. 5 mm THRUST WASHER 5 mm SOCKET BOLT RUBBER WASHER 5 mm WELL NUT METER VISOR ACCESSORY STAY METER VISOR STAY METER VISOR STAY 2 of 3 7. Route the cables as shown. CLUTCH CABLE METER VISOR STAY THROTTLE CABLE GUIDE 8. Move the handlebar right and left, and check that this accessory does not interfere with the motorcycle parts. 3 of 3Acrobat Distiller 20.0 (Windows)