EVERBILT

Improper installation can cause failure, leaks, floods, and property damage. Always follow building codes and construction standards.

Before Installing:

• Shut off water, gas, and electricity to the appliance before installing.
• Select the proper length for the job.
• Ensure a minimum bend radius of 2.5 inches.
• Inspect the product before installing.
• This part must be inspected after installation every six months thereafter (more frequently if you have "hard water").

For Use With:

• Water in accessible locations only.
• Continuous pressure less than 125 psi and maximum intermittent impulse pressure of 180 psi.
• Continuous temperature less than 160°F maximum; intermittent exposure of 180°F.

DO NOT:

• ✔️ Use for gas.
• ✔️ Install with twists, kinks, sharp angles, or loops in the line, which can damage the line internally.
• ✔️ Use if damaged in any way.
• ✔️ Use thread lubricants, tape, or putty.
• ✔️ OVER-TIGHTEN. Over-tightening can damage the line, connectors, and seals. For metal nuts, hand-tighten plus ¼ turn with a wrench.

Maintenance and Replacement:

Shut off water immediately and replace if signs of damage, cracks, kinks, twists, corrosion, wear, breaks, leaks, or weeping are present.

DO NOT reuse.