Logic Concept Atos ARGB Mini PC Case

Introduction

This manual provides comprehensive information for the Logic Concept Atos ARGB Mini PC case. Designed for builders seeking a compact yet feature-rich enclosure, the Atos ARGB Mini supports a variety of motherboard form factors and offers excellent airflow and aesthetic customization through its integrated ARGB lighting.

Key Features

• Integrated ARGB Lighting: Customizable lighting effects controllable via motherboard software or a dedicated button. ?
• Compact Form Factor: Optimized for Mini-ITX and Micro-ATX motherboards, fitting easily into smaller spaces.
• Tempered Glass Side Panel: Showcase your build with a clear, durable tempered glass window. ?
• Optimized Airflow: Designed with multiple fan mounts and ventilation points for efficient cooling. ?
• Versatile Storage: Supports multiple SSD and HDD drives. ?
• Front Panel I/O: Convenient access to USB ports and audio jacks. ?

Specifications

Installation Guide

Follow these general steps to build your PC inside the Atos ARGB Mini case. Always ensure the system is powered off and unplugged before performing any hardware installations. ?

Step 1: Preparation

Unpack all components. Remove the side panels of the case. Identify all screws and accessories provided.

Step 2: Motherboard Installation

Install the CPU, RAM, and M.2 SSD (if applicable) onto the motherboard before mounting it into the case. Align the motherboard with the standoffs inside the case and secure it with screws. Ensure the I/O shield is correctly installed in the case cutout. ⬆️

Step 3: Graphics Card (GPU) Installation

Remove the appropriate expansion slot covers on the rear of the case. Align the GPU with the PCIe slot on the motherboard and press down firmly until it clicks. Secure the GPU bracket to the case with screws. ➡️

Step 4: Storage Drive Installation

Mount your 3.5" HDDs or 2.5" SSDs into the designated drive bays or mounting points. Secure them with screws. ?

Step 5: Power Supply Unit (PSU) Installation

Install the PSU into its designated compartment, usually at the bottom rear of the case. Secure it with screws from the outside. ⬇️

Step 6: Cable Management

Connect all necessary power and data cables from the PSU to the motherboard, GPU, and storage drives. Route cables through the case's cutouts and tie them down using zip ties or Velcro straps for a clean build and improved airflow. ?

Step 7: Front Panel Connectors

Connect the case's front panel cables (power button, reset button, USB, audio, ARGB) to the corresponding headers on the motherboard. Refer to your motherboard manual for correct header locations. ?

Step 8: Final Checks

Double-check all connections. Ensure no loose screws or cables are obstructing fans. Reattach the side panels. ✔️

ARGB Lighting Control

The Atos ARGB Mini features integrated addressable RGB lighting. To control the lighting:

• Motherboard Sync: Connect the ARGB header cable from the case to the 3-pin ARGB header on your motherboard. Use your motherboard's RGB software (e.g., ASUS Aura Sync, MSI Mystic Light, Gigabyte RGB Fusion) to customize colors and effects. ?
• Manual Control: If not connecting to the motherboard, the case may have a dedicated button (often on the top panel) to cycle through pre-set lighting modes and colors. ?

Note: Ensure the ARGB power cable is also connected to the PSU if required by the specific lighting controller.

Safety and Care

• Tempered Glass: Handle the side panel with care to avoid scratches or impacts. Clean with a soft, damp cloth. ?
• Cleaning: Use a soft, dry cloth for dusting. For stubborn marks, use a slightly damp cloth and ensure the case is dry before powering on. Avoid harsh chemicals. ?
• Ventilation: Ensure all fan mounts and ventilation grills are unobstructed to maintain optimal cooling performance. ?
• Electrical Safety: Always disconnect power before cleaning or performing maintenance. ⚡