User Manual for Infinix models including: X6720B HOT 50 5G Smart Phone, X6720B, HOT 50 5G Smart Phone, 5G Smart Phone, Smart Phone, Phone

Sanjeev

daishengsheng Microsoft

Users Manual

INFINIX MOBILITY LIMITED X6720B 2AIZN-X6720B 2AIZNX6720B x6720b


File Info : application/pdf, 9 Pages, 200.51KB

PDF preview unavailable. Download the PDF instead.

GetApplicationAttachment.html?id=7600138
Infinix
HOT 50 5G
X6720B User Manual(T)

Exploded diagram specification

1

TP+LCM

3

SIDEKEY FPC

5

MAIN PCB HEAT FILM

7

8W CAMERA

9

RECEIVER

11

COAXIAL CABLE 2

13

FRONT CAMERA

15

REAR FLASH LIGHT FPC

17

FINGERPRINT FPC

19

BLACK SCREW

21

BATTERY COVER

23

COMPOSITE PANEL DECO

25

CAMERA LENS 2

27

SUB BOARD

29

MOTOR

31

EARJACK RUBBER

33

SILVER SCREW

2

FRONT COVER

4

MAINBOARD

6

REAR 48M CAMERA

8

REAR CAM COPPER

10

COAXIAL CABLE 1

12

BATTERY

14

MIDFRAME

16

REAR LIGHT SENSING FPC

18

FINGERPRINT FPC FIX MYLAR

20

SIMCARD HOLDER

22

DECO

24

CAMERA LENS 1

26

CAMERA LENS 3

28

SPEAKER

30

USB RUBBER

32

ANTENNA SHRAPNEL

Know your phone
1

1. Front camera 2. Volume + button 3. Volume - button 4. Power button & side fingerprint sensor 5. NFC
SIM/SD card installation
2

1. Power off your phone. 2. Refer to the following picture for SIM/SD card installation.
1

Charging the phone
You can charge your phone with a charger or by connecting it to a computer using a USB cable (comes with the phone). Use only Infinix chargers and cables. Other chargers or cables may damage the phone and invalidate its warranty.
2

FCC Caution
Labelling requirements. This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.
Information to user. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
Information to the user. Note: This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and may radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception (able to be determined by turning the device off and on), the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the device and receiver. -Connect the device to an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
3

Specific Absorption Rate (SAR) information: This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement. The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: X6720B (FCC ID: 2AIZN-X6720B) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.500 W/kg and when properly worn on the body is 0.692 W/kg.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user's body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
4

For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights Reserved.
Operating System: AndroidTM Android is a trademark of Google LLC.
5



References

daishengsheng Adobe PDF Library 15.0