Delux Vertical Mouse User Manual
Thank you for choosing this special wireless vertical mouse. Please read the user manual carefully when using this product.
Contents
- Wireless vertical mouse - X1
- User manual - X1
- USB nano receiver - X1
- CD driver for optional - X1
Features
Vertical mouse, worm bionic shape design.
Installation
Plug the USB connector for wired mouse (or USB Nano receiver for wireless version) to the USB port in the computer. After detecting successfully, it will work normally.
Specification
DPI | Polling rate | Working Voltage | Working Current |
---|---|---|---|
800/1200/1600 | 125Hz | 1.5V | < 20mA |
Receiver Connection
Equip the mouse with a battery. Insert the Nano receiver to the USB port of your computer. Push the ON button on the bottom of the mouse, and the receiver will detect the device automatically. Plug and play.
The red light will flash once if you shift the DPI to the first gear, will flash twice when you shift the DPI to the second gear, etc. Also, it will flash when the voltage is low.
Driver Instruction
- Installation
Download the driver from www.deluxworld.com or use the CD in the package to install the driver.
Note: Please make sure this mouse is already connected to the computer when setting the functions in the driver. - Setting
These functions can be customized as below. A screenshot shows the driver interface with customization options.
Macro Setting
Click "Assign Macro" to enter Macro settings. Click NEW and name the macro. Click "Left click" on any blank space below MACRO SELECT to confirm the name. Then, click "Start Record". After finishing the record, click "STOP RECORD", and then click "OK" to save the macro. After choosing a certain macro, the background of this macro will turn green. You can edit the macro.
Other Functions
- Basic: Cut, Copy, Paste, etc. (8 functions available)
- Advanced: Switch window, close window, etc. (6 functions available)
- Media: Previous track, next track, stop, etc. (7 functions available)
You can also adjust the speed of tracking, double-click, and scrolling.
After setting the functions, please click "Apply". If you need default functions, just click "Restore Defaults".
Building Up the Connection Between Mouse and Receiver
If your mouse cannot work normally, you can try to build up the connection again between the mouse and receiver, as following steps:
- Take out the Nano receiver from the computer and insert it again. It will detect automatically for about 15 seconds.
- Keep the mouse in ON mode and with the battery in the correct direction.
- Keep the effective distance within 10 CM between the mouse and receiver.
- Press the middle button (scroll wheel) and the right button at the same time for about 1-3 seconds, then release them. The connection is being built for about 10 seconds.
- If you cannot build up the connection in 10 seconds, please repeat the above steps.
Debugging Tips
- Check if the receiver is connected to the USB port.
- Check if the ON/OFF button is in the ON mode.
- Check the effective distance between the mouse and receiver and shorten it.
- Rebuild up the connection between the mouse and receiver.