Cecotec Bamba PrecisionCare Skull Head Shaver

1. Parts and Components

Refer to the diagram (Fig. 1) for component identification:

• 1. Rotary head
• 2. Power button
• 3. LED display (shows battery level, e.g., 188%)
• 4. Charging base
• 5. USB cable
• 6. Cleaning brush

Note: The graphics in this manual are schematic representations and may not exactly match the device.

2. Operation

Charging the Device

• Charge the appliance to full power before first use or after a long period of inactivity.
• Ensure the appliance is switched off.
• Connect the charging cord to the product and then to a compatible power adapter.

*The battery lifespan may be reduced depending on usage and hair type.

Corded and Cordless Use

• Connect the charging cord to the product when switched off, and then to a compatible power adapter for corded use.
• The device can also be used without connecting the charging cable (cordless use).

3. Cleaning and Maintenance

Clean the shaver regularly to ensure better shaving results. Remove and wash the head after each use.

1. Turn off the shaver, remove the shaving head, and disassemble it for cleaning (Fig. 2). To do this, lift the outer blades and turn the central blade counterclockwise to unlock it.
2. Clean the head thoroughly with the cleaning brush and under running water.
3. Do not use abrasives, alcohol, petrol, acetone, or similar products to clean the appliance.
4. Allow the head to dry before reassembly. Do not dry the shaver head with a towel or paper, as it may be damaged.
5. Clean the body of the device after each use with a soft cloth.
6. Once dry, reassemble the head by turning the central blade clockwise and closing the side blades, and place it on the body of the device before using the product again (Fig. 3).
7. For best shaving results, lubricate the appliance every three months. Lubricating oil is not supplied with the device and must be purchased separately.

4. Head Replacement

Replace the shaving head at least once a year to ensure good shaving results. Use only original heads from the manufacturer to replace a broken or worn head.

1. Hold the body of the appliance with one hand and gently pull the head with the other hand to remove it.
2. Align the new shaving head with the grooves on the top of the shaver and push it down until you hear a snapping sound.

5. Technical Specifications

6. Disposal of Old Electrical and Electronic Appliances

This symbol ♻️ indicates that, according to applicable regulations, the product and/or battery must be disposed of separately from household waste.

When this product reaches the end of its shelf life, dispose of its cells/batteries/accumulators at a collection point designated by local authorities.

Consumers should contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.

Compliance with these guidelines helps protect the environment.

7. Technical Support and Warranty