Nokia Essential True Wireless Earphones E1200 User Guide
This document provides instructions and safety information for the Nokia Essential True Wireless Earphones E1200.
Getting Started
Powering On
To power on the earphones, press and hold the power button for approximately 3 seconds.
[Diagram: Headphones and charging case. A hand is shown pressing a button on the headphones.]
Pairing Mode
To enter pairing mode, press and hold the power button for approximately 7 seconds until the LED indicator flashes red and blue. On your device (e.g., smartphone), navigate to Bluetooth settings, search for available devices, and select "Nokia E1200" to connect.
[Diagram: Headphones, smartphone displaying Bluetooth settings with "Nokia E1200" listed, and headphones with red/blue flashing LED.]
Charging
Connect the earphones to the charging case using the provided USB cable. The LED indicator on the earphones will show a red light during charging and will indicate completion (e.g., turn off or blue) when fully charged.
[Diagram: Headphones being placed into a charging case, connected via USB cable to a power source.]
Troubleshooting
| Problem | Reason | Solution |
|---|---|---|
| Does not power on / Does not respond | Battery is low | Charge the headphones for 2-3 hours and restart. |
| No sound after pairing | Incorrect pairing | Pair the headphones again or reset the headphones. |
| Turns off automatically | Battery is low | Charge the headphones for 2-3 hours. |
| Red light flashes on headphones | Battery is low | Charge headphones. |
| Failing to charge | Error with power supply | Perform a hardware reset. |
| No light when charging | Error with power supply | Check charging cable is plugged in and ensure power is on. |
| Hearing an echo | Volume is too loud or the environment is too noisy | Adjust the volume or change your location. |
| Noise in-call | Noisy environment or distance between earphones and mobile phone is too far | Change location or bring earphones and mobile phones closer together. |
| Sound occasionally drops | Environmental interference or out of Bluetooth transmission range | Change location with less signal interference or reduce the distance between the headphones and devices. |
| Sound is too soft | Low volume | Increase the volume. |
Controls
Controls are applicable in Bluetooth mode.
Music Controls
- Play/Pause: Press the power button once.
- Next Track: Press and hold the '+' button for 2 seconds.
- Previous Track: Press and hold the '-' button for 2 seconds.
- Volume Up: Press the '+' button.
- Volume Down: Press the '-' button.
Call Controls
- Answer/End Call: Press the power button once.
- Reject Call: Press and hold the power button for 2 seconds.
Voice Assistant
- Activate Voice Assistant: Press and hold the power button for 2 seconds.
[Diagram: Icons representing music playback controls (play/pause, next, previous, volume up/down) and call controls (answer/end, reject) with corresponding button presses.]
Specifications
| Feature | Specification |
|---|---|
| Wearing style | Wireless Headphones |
| Ear coupling | Circumaural |
| Frequency response | 20 Hz to 20kHz |
| Transducer principle | Dynamic, closed |
| Transducer size | 40mm |
| Sound pressure level (SPL) | 106dB(1kHz/ 1mW) |
| Impedance | 32Ω |
| Microphone principle | ECM x1 |
| Power supply | Built-in Lithium rechargeable batteries, 3.7V, 500mAh |
| Operating time | 40 hours (music playback via A2DP)* |
| Charging time | Approx. 3 hours |
| Weight | Approx. 197g |
| Volume Control | Yes |
| Bluetooth Version | Bluetooth specification version 5.0 |
| Profiles | HFP, AVRCP, A2DP |
| Effective Range | Line of sight approx. 30ft (10m) |
| Transmission frequency | 2402 MHz to 2480 MHz |
| Supported Audio Format(s) | SBC |
* Battery life depends on device settings, environment, usage, and many other factors.
Reset
To reset the headphones to factory settings, press and hold the power button and the volume down button simultaneously for 5 seconds.
[Diagram: Headphones with buttons highlighted for reset action.]
Safety Guide
Please read the following safety instructions carefully before using the product.
- Hearing Protection: Do not listen at high volume levels for extended periods to prevent hearing damage.
- Magnetic Field Warning: The product generates magnetic fields. Maintain a distance of at least 10 cm (3.94 inches) from cardiac pacemakers, implanted defibrillators (ICDs), or other implants to prevent interference.
- Choking Hazard: Keep the product, accessories, and packaging out of reach of children and pets.
- Usage Environment: Do not use the product in environments requiring special attention, such as traffic.
- Product Care: Keep the product dry and avoid extreme temperatures (e.g., hairdryer, heater, direct sunlight) to prevent corrosion or deformation. Normal operating temperature is 0°C to 40°C (32°F to 104°F).
- Accessories: Use only attachments, accessories, and spare parts supplied or recommended by RichGo.
- Cleaning: Clean the product only with a soft, dry cloth.
Battery Safety Warnings
- Rechargeable batteries may leak, cause fire, explosion, or heat generation if abused or misused.
- Dispose of defective products with built-in rechargeable batteries at special collection points or return them to a specialist dealer.
- Use only rechargeable batteries and chargers recommended by RichGo.
- Charge batteries only at ambient temperatures between 10°C (50°F) and 40°C (104°F).
- Switch off battery-powered products after use.
- Recharge batteries regularly (about every 3 months) if not used for extended periods.
- Do not heat batteries above 70°C (158°F), avoid sunlight, and do not throw batteries into fire.
[Diagram: Icons representing warnings, such as a hearing protection symbol, a magnet warning symbol, and a battery warning symbol.]
Intended Use and Liability
This product is designed for wireless audio communication, such as music playback and phone calls, using Bluetooth technology. Any use not specified in the product guides is considered misuse. RichGo is not responsible for damages resulting from misuse, incorrect application, or unauthorized modifications. Warranty may be voided under conditions such as unauthorized repair, mishandling, damage from natural disasters, accidents, liquid damage, or commercial/rental use. All replaced parts become the property of the manufacturer. Warranty covers only the product's main hardware; accessories are not covered.
Manufacturer Declarations
EU Declaration of Conformity
RichGo declares that this product conforms to EU Directive 2014/53/EU. The full Declaration of Conformity can be requested via the website: www.nokia.com/shop/support.
Recycling Information
Please return used electronic products, batteries, and packaging materials to dedicated collection points. This helps prevent uncontrolled waste disposal and promotes material recycling. Electrical and electronic products contain valuable materials. The crossed-out wheelie bin symbol [Recycling Symbol] on the product, battery, literature, or packaging indicates that these items must be taken to separate collection at the end of their working life and not disposed of as unsorted municipal waste. Check with your local waste authority for information on your nearest recycling point.
China RoHS
The China RoHS table indicates the presence of hazardous substances (Lead, Mercury, Cadmium, Hexavalent Chromium, PBB, PBDE) in product components. 'x' denotes that the content of the hazardous substance exceeds the limit specified in GB/T 26572, while 'o' denotes that the content is within the limit.
China Battery Warning
Do not disassemble, impact, squeeze, or throw batteries into fire. Do not place in high-temperature environments. Do not use if severely swollen. Do not use if battery is water-damaged.
Taiwan Low Power Radio Warning
This device operates under low power radio frequency regulations. Modifications to frequency, power, or design without permission are prohibited. Usage must not affect flight safety or interfere with legal communications. Interference must be addressed immediately. The device must tolerate interference from legal communications or industrial, scientific, and medical equipment.
Brand and Support Information
RichGo Technology (Shenzhen) Co.Ltd is a licensee of the Nokia brand for earphones and mobile accessories. Nokia is a registered trademark of Nokia Corporation. The BLUETOOTH® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by RichGo is under license.
For product support, please visit http://www.nokia.com/shop/support or call 4009993019 (CN).
