Happy & Polly Pet Water Fountain User Manual

About the Product

This manual provides essential information for the Happy & Polly Pet Water Fountain, designed to offer your pet a continuous supply of fresh drinking water.

Key Features

• Battery-powered operation for flexible placement.
• Multiple dispensing modes: Timer, Sensor, and Continuous Flow.
• Low water level indicator for convenience.
• Easy-to-clean components, including stainless steel parts.

Important Precautions

• Keep packaging materials away from children and pets.
• Do not immerse the battery compartment in water.
• Use only approved DC 5V 1A power adapters.
• Never operate the fountain without water in the tank.
• Follow local regulations for battery disposal.

Usage Notes

• The fountain is compatible with DC 5V 1A power adapters.
• Avoid operating or storing the fountain in extreme temperatures.
• For extended periods of absence, check water level and battery status.

Battery-Powered Operation

Modes

• Timer Mode: Automatically dispenses water every 15 minutes for 15 seconds.
• Sensor Mode: Dispenses water for 15 seconds upon detecting motion within a 120° angle and 1.5m range. It also auto-dispenses every 2 hours if no motion is detected, ensuring water circulation.
• Continuous Flow Mode: Achieved by connecting the device to power while in Timer Mode.

Indicator Light & Button Guide

Battery Indicator

• Flashing Blue: Charging
• Solid Blue: Fully Charged
• Flashing Red: Low Battery (below 3.3V)
• Solid Red: Critical Battery Level (below 3.0V)
• Auto Shutoff: Below 2.9V

Operating Mode Indicators

• Timer Mode: Solid White (dispensing), Flashing White (standby).
• Sensor Mode: Solid White (dispensing after motion), Flashing White (detecting motion).

Low Water Level Indicator

• A red indicator light turns on when the water pump detects insufficient water.

Button Functions

• Power On/Off: Press and hold the button for 2 seconds.
• Switch Modes: Short press the button while the device is on.

Setup and Maintenance

In the Box

• Battery Pack
• Stainless Steel Water Tray
• Filter
• Filter Tray
• Stainless Steel Water Tank
• USB-C Cable

How to Use

Setup Steps

1. Prepare Filter: Soak the filter in clean water for 5 minutes and rinse thoroughly.
2. Clean Parts: Rinse the water tray, filter tray, and water tank. Stainless steel parts are dishwasher safe.
3. Fill Water Tank: Fill the tank with clean water.
4. Insert Filter: Place the filter tray and then the filter into the tray.
5. Connect Pump and Main Unit: Attach the main unit securely to the water pump.
6. Install Main Unit: Fit the assembly into the top cover of the fountain.
7. Power On: Press and hold the button for 2 seconds.

How to Charge

Open the battery pack's rubber cover, connect the included USB-C cable to the charging port, and plug the adapter into a power outlet.

Maintenance Guidelines

• Replace the filter and pump sponge every 2-4 weeks.
• Clean the pump and spout every 1-2 weeks.
• Always ensure the water tank is filled before powering on the pump to extend its lifespan.

Troubleshooting

Pump Not Working

• Ensure the water level is above the pump.
• Clean the pump, water tank, and drinking tray.

Device Won't Power On

• Check for moisture on contact points between the tray and battery compartment. Dry thoroughly before trying again.

Water Flows Slowly or Splashes

• Check if the water level in the tank is too low; refill if necessary.
• The pump may be clogged; clean the pump and spout.
• Ensure the tray is level and properly installed.