DECKED Truck Bed Storage, Tool Boxes & Truck AccessoriesDECKED® Toolbox Ladder Complete Guide
Instruction Manual for DECKED models including: RC618 Ladder for Tool Box Ladder Bracket, RC618, Ladder for Tool Box Ladder Bracket, Tool Box Ladder Bracket, Ladder Bracket, Bracket
DECKED Installation: DECKED Installation Videos & Instructions
Installation manuals – DECKED Australia
File Info : application/pdf, 2 Pages, 5.21MB
DocumentDocumentCAB A LADDER INSTALLATION TOOLSNEEDED: · 5/32" hex wrench LADDER BRACKET · Check to see that the ladder pivot brackets are installed - (orange in Detail A). If not, see previous page. · Rest the folded ladder on a table or hard surface so that you can read the instructions on the bottom of the first rung. DETAIL A · While holding the top rung, pull the bottom rung from the ladder assembly until both the bottom and middle rungs lock in place. · Set the ladder on the ground vertically next to the passenger side of your Tool Box. · Raise both arms and extend them up and over the edge of the Tool Box to meet with the mounting discs. NOTE: The ladder brackets must be facing down. · Using a 5/32" hex wrench, install the hardware in the order shown, DETAIL A. Repeat on opposite side. Tighten until snug - DO NOT OVERTIGHTEN. · Return the ladder to the Tool Box by collapsing the rungs and folding back into place. USING THE LADDER: STEP 1 STEP 2 STEP 3 POSITION LADDER VERTICALLY TO SOLID GROUND "CLICK" "CLICK" AGAIN WARNING DON'T DO THIS PLACE LADDER ON SOLID GROUND WITH BOTH RUNGS LOCKED INTO PLACE (LADDER STEPS 1-3). FAILURE TO DO THIS COULD ALLOW LADDER TO SWING INTO TRUCK AND CAUSE DAMAGE TO THE VEHICLE WATCH LADDER INSTRUCTIONAL VIDEOS: DECKED.COM/LADDER FOLLOW US: DECKED.COM | #DECKEDUSA | @DECKEDUSA @DECKEDUSA | #DECKEDUSA RC618| v.3 | Page 2