Assembly Instructions
Parts List
- Part A: Side Panels (x2)
- Part B: Backrest (x1)
- Part C: Sofa Seat/Base (x1)
- Part D: Support Blocks (x4)
- Part E: Cushions (x2)
- Part F: Pull-out Bed Base (x1)
- Hardware 1: Screws (x8) ?
- Hardware 2: Dowels (x2) ?
Assembly Steps
Step 1: Attach Support Blocks
Attach the support blocks (D) to the inside of the side panels (A) using eight screws (1). Ensure the blocks are oriented correctly for later attachment.
[Diagram shows two Part A panels, each with two Part D blocks being screwed into place using eight screws (1).]
Step 2: Connect Side Panels
Connect the assembled side panels (A) to the main sofa seat/base (C). The side panels should slot into place on the sides of the seat/base.
[Diagram shows Part A panels being attached to the sides of Part C.]
Step 3: Attach Backrest
Attach the backrest (B) to the rear of the sofa assembly. The backrest has metal brackets that slot into corresponding receivers on the side panels (A). Ensure correct orientation.
WRONG!
[Diagram shows incorrect bracket alignment.]
YES
[Diagram shows correct bracket alignment.]
[Diagram shows Part B being lowered onto the back of the sofa assembly, with visual cues for correct bracket insertion.]
Step 4: Place Cushions
Place the cushions (E) onto the backrest (B).
[Diagram shows two Part E cushions being placed on top of Part B.]
Step 5: Extend Bed Base
To convert the sofa to a bed, pull out the lower section (F) from beneath the sofa seat (C).
[Diagram shows Part F being pulled forward from under Part C.]
Pre-Assembly Tips
We get it - building furniture isn't always easy! But have no fear, helpful hints are here. Our assembly tips and tricks will have you enjoying that new furniture in no time. Let's get construction ready to rock!
- ❌TEAM ASSEMBLY: Have at least 2 people put the product together to prevent injury and damage.
- ❌ASSEMBLE IN PLACE: Put together near the intended location to avoid moving later.
- ❌CLEAR WORKSPACE: Ensure ample room to maneuver during assembly.
- ❌AVOID SCRATCHES: Assemble on cardboard, blankets, or carpet to prevent scratches.
- ❌FLAT SURFACE: Place on a level surface with furniture legs evenly contacting the floor.
(Note: The original document uses checkmarks (✔️) to indicate the correct method for each tip. The above lists the incorrect method with a cross (❌) for brevity, implying the opposite is correct.)
Assembly Safety Steps
⚠️ FAILURE TO FOLLOW THE GUIDELINES BELOW MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE.
POSITIONING: Insert all hardware and parts in the correct holes. ?
[Diagram shows a screw being inserted into a hole.]
TIGHTENING: Only tighten bolts when the step is fully completed. ?
[Diagram shows a screw being tightened with a tool.]
TOOLS: Use hand tools unless the manual specifies power tools. ?️
[Diagram shows a hand tool and a power drill symbol with a warning icon.]
INSTRUCTIONS: Keep the manual and tools for future maintenance needs. ?
[Diagram shows a manual and tools.]
MAINTENANCE: Check for loose joints after 2 weeks and re-tighten every 6 months. ✋
[Diagram shows a hand tightening a joint.]
Disclaimer
It is the user's responsibility to properly maintain the furniture over its lifetime. Hardware such as screws, bolts, and other fasteners may naturally loosen over time with normal use of the product. This can lead to instability if the furniture is unable to adequately support the intended weight capacity. To prevent injuries, following the maintenance instructions is key to ensuring product safety and longevity.
